luminii FL Channel Service manual
REV3.2
FL Channel - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
www.luminii.com
Page 1 of 2
STEP A STEP B STEP C
12
43
If required for installation cut down FL extrusion to
desired length with hacksaw or miter saw that has an
appropriate blade for cutting aluminum. Always wear
safety goggles when cutting.
FL extrusion
The FL extrusion can be attached to the mounting surface with
screws or adhesive. These instructions explain how to install the
extrusion using both mounting options (step 4 and step 5).
5
2.06”
0.31”
Use the body of the extrusion and dimensions from step 1
to mark installing position on the mounting surface.
0.66” 0.70”
0.70”
Construction adhesive can also be
used to attach the extrusion to the
mounting surface (instead of screws).
Apply adhesive following instructions
of adhesive manufacturer for material
compatibility and drying time.
construction
adhesive
TYP. 30” O.C .
Ensure the
correct drill bit
is used to drill
in the aluminum
extrusion
Drill location for mounting holes at appropriate in-
tervals and in the middle of the FL extrusion. Follow
steps A,B,C below.
Ensure flathead
screws are tightened
flush with or below
aluminum extrusion
Countersink
holes for
flathead
screws
REV3.2
FL Channel - Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
www.luminii.com
Page 2 of 2
solder
pads
If required to fit the extrusion length, cut down the Line LED strip
in between two rows of solder pads. Always cut Line LED from
end without connector/wire leads. Ensure that Line LED strip fits
completely inside the extrusion and the solder pads do not touch
any metal parts as to avoid shorting of circuit.
Line LED strip
wire
leads
8
7
feed wires from line LED
to the power supply
through the hole in the
end cap
endcap
line LED
paper
backing
Once the extrusion is in place, install the line LED strip
by removing backing and pressing on to extrusion.
Then install end caps, and finally snap on the lens.
Remove the protective film from the lens.
lens
9
Ensure power is off to power supply!
Then proceed to connect line LED wires from FL extrusion to
power supply. Connection can be established with lead wires
or quick-connect powerfeed. For more information please refer
to power supply and line LED wiring instructions.
power to Line LED
of FL extrusion
class II
power
supply
line voltage wires low voltage wires
If you ordered the endcaps that also have
mounting ears, you can use those to attach
fixture to the mounting surface, after it has
been completely assembled (follow previous
instruction steps for assembly).
mounting
brackets
mounting
screws
wires to
power
supply
installation with mounting brackets
6
film
