Lush Banners TT-FO-02-BLIT User manual

Trade Show Tower Sqaure (Backlit) 12ft
TOP VIEW

Components, Connectors & Graphic
TC-30-3W-R x8 COL-T1 x6
TC-30-X x2
LED-CORN-24W x9 COL-01-BL-G x1
COL-T6 x4
WC-30T x3
COL-T2 x8
COL-T5 x2
COL-T4 x1
LED-LT-FXT-3WAY x3
Included In Your Kit
COL-T3 x8
LED-LT-PWR-CORD x3
WIRE CONNECTION CLIP x3
Graphic

Labeling Diagram
Section 1:

Labeling Diagram
Section 2:

Labeling Diagram
Section 3:

Lighting Diagram
WC-30T
TYP. x4
LED-LT-PWR-CORD x3

Gather the components to build
Section 1 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods 2
for more details.
Gather the components to build
Section 3 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Methods
1, 2, and 3 for more details.
Gather the components to build
Section 2 of the tower frame.
Use the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 3
and 4 for more details.
Lay the three sections flat on
floor. Combine them to complete
the tower frame assembly. Use
the Exploded View and the
Labeling Diagram for part labels.
Reference Connection Method 1
and 2 for more details.
Step 1.
Step 3.
Step 2.
Step 4.
Kit Assembly
Step by Step

Once the unit is upright, test the
power connection to the lights.
Adjust for minimizing shadowing
and hot spots.
Setup is complete.
Step 5.
Step 7.
Step 6.
Kit Assembly
Step by Step
-See Light Diagram
Close the zippers and carefully
set the frame upright.
Gather the components to
connect lighting to the frame.
Connect the lighting components
to the frame. Use the Exploded
View and Lighting Diagram for
part labels. These components
simply hang from tube T4 at the
top of the frame and the power
cable runs down and out of the
bottom opening.

Connection Method 1: SNAP BUTTONS
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Connection Methods
Connection Method 2: TC-30-3W-R
Snap button connections are simple and easy to use. First, locate the snap button on the connector
or swage tube. Second, locate the hole on the corresponding tube. Press the snap button with your
thumb and slide the tube and connector together so that the snap button snaps fully into the hole.
To disassemble, press the snap button and carefully pull them apart.
Slide the COL-T3 into the COL-T6 until it snaps in place. Repeat this for all 4 bottom COL-T2
sections.
Connection Method 3: COL-01-T6/ COL-01-T3 Connection Method 4: TC-30-X
First, connect spreader tubes (COL-T3) to TC-30-X. Second, once the X frame is assembled, connect
side tubes (COL-T6).