Magic FLEXBOX User manual

SKU: FLX1.9
FLX2.14
FLEXBOX PROGRAMMING TOOL FOR THE
AUTOMOTIVE SECTOR
USER
FLEXBOX - BORN TO BE FLEXIBLE
This manual contains information on the features and operation of FLEXBox when used
with the FLX2.14 FLEXBox OBD Female cable.
The manual illustrates the basic instructions for proper operation and describes the
functions that are enabled when connecting with the FLX2.14 cable.

FLX2.14
CAN-HI
CAN-LO
K-LINE
L-LINE
SLOW BLINKING LED 0 Volt (~ mA)
FAST BLINKING LED 3,3 Volt (~ mA)
SHORTCUT
+5 Volt (~ mA)
TAP
FIRST FUNCTION
SETUP PHASE
12345678
910 11 12 13 14 15 16
+14V
L-LINE
CAN-L
CAN-H
K-LINE
st
FLX2.14 PIN OUT
PLUG THE 2.14 FLEX CABLE INTO THE FLEXBOX DB44 SOCKET
CONNECT THE FLEXBOX TO THE POWER SUPPLY
THE LINES WILL LIGHT UP AS SHOWN
FLEXBOX INTERFACE VIA COLORED SILICON CABLES WITH THE UNIT
FLEXBOX INTERFACE VIA 2.14 FLEX CABLE WITH THE PROGRAMMER
WAIT FOR THE BUTT TO LIGHT UP AND TAP

+14 Volt POWER SUPPLY
TAP
FLX2.14
CAN-HI
CAN-LO
K-LINE
L-LINE
SLOW BLINKING LED 0 Volt (~ mA)
FAST BLINKING LED 3,3 Volt (~ mA)
SHORTCUT
+5 Volt (~ mA)
nd
+14 Volt
AUT IGN
ON
IGNITION
AUTOMATICALLY
CONTROLLED BY
K-LINE
+14 Volt
THIRD FUNCTION
FLX2.14 PIN OUT
12345678
910 11 12 13 14 15 16
+14V
L-LINE
CAN-L
CAN-H
K-LINE
FLX2.14
CAN-HI
CAN-LO
K-LINE
L-LINE
SLOW BLINKING LED 0 Volt (~ mA)
FAST BLINKING LED 3,3 Volt (~ mA)
SHORTCUT
+5 Volt (~ mA)
rd TAP
SECOND FUNCTION
12345678
910 11 12 13 14 15 16
+14V
L-LINE
CAN-L
CAN-H
K-LINE
FLX2.14 PIN OUT

FLX2.14
CAN-HI
CAN-LO
K-LINE
L-LINE
SLOW BLINKING LED 0 Volt (~ mA)
FAST BLINKING LED 3,3 Volt (~ mA)
SHORTCUT
+5 Volt (~ mA)
IGN MANAGED
BY THE USER
+14 Volt P.S.
+14 V / 0 Volt
th TAP
LOOP MODE
PRESS 3 SEC
TO RESET
EACH PUSH
IGN ON/OFF
LOOP MODE
TAP K-LINE ING
st
nd
0 V 0 V
14 V 14 V
IN LOOP MODE IT IS POSSIBLE TO SWITCH BETWEEN 0V AND 14V (referred to A4):
KEEP PRESSED 3 SECONDS TO EXIT THE LOOPMODE AND RETURN TO THE FIRST FUNCTION.
A4
FLX2.14 PIN OUT
FOURTH FUNCTION
12345678
910 11 12 13 14 15 16
+14V
L-LINE
CAN-L
CAN-H
K-LINE