Magma MAC PRO SLED Programming manual

1
09-10013-00REV.A2/13/2014
MACPRO®SLED ASSEMBLYINSTALLATIONINSTRUCTIONSFORRKIT-MP
(PartNumberUPGMP-SLD)
1.Install the MACPRO®units onto the computermounting brackets with the clamps provided, using a flat
horizontal work surfacesuchas a desk orworkbench. Anillustration of assembling the MAC PRO®into
its bracketwhile resting on a horizontal surface isshown. (See Figure 1.)
Make sure the thumbscrews are tight and the MACPROis secure. (See Figure 2.)
Figure1
Figure2
3

2
09-10013-00REV.A2/13/2014
2.Using the hardware kitincludedwith the shelf, install the screws and nuts onto the front of the rack atthe
location the shelfwill be installed. (See Figure3.)
Figure3
3. Carefully slide the sliderbracketwith theMACPROinstalled,into the mountedshelf. Using the two
thumbscrews on the front of the brackets to secure the sliderto shelf.(SeeFigure 4.)
Figure4
4.Install external cables andtie along the mounting bracketusing Velcrostraps providedas shown.
(See Figure 2.)
FOR QUESTIONSCONTACTUSAT+1(858)530-2511OR SUBMITA REQUESTAT WWW.MAGMA.COM/SUPPORT