INSTRUCTIONS
RECON WILDLIFE CAMERA
PACKAGE CONTENTS
•Trail cam
•Strap
•USB charging cable
•USB to microSD adapter
•Instruction manual
TECHNICAL SPECIFICATIONS
•Image sensor: 3 MP color CMOS
•Photo resolution: 12 MP
•Video resolution: 1080p full HD @ 25 fps
•Lens angle: 120°
•Sensor range: 15 m
•MAX microSD size: 32 GB (not included)
•Power supply: 4 × AA battery (not included)
•Water resistance: IP56
•Standby time: 12 months
•Size: 55 × 90 × 135 mm
•Weight: 160 g
COMPONENTS
1. Battery compartment 1
2. Micro-USB power supply
3. MicroSD slot
4. ON/OFF switch
5. Battery compartment 2
6. Locking screw
HOW TO INSTALL THE BATTERIES
•Open the hub at the bottom of the camera
by unscrewing the locking mechanism.
•Press onto the battery compartment cover
to open it.
•Insert two AA batteries (not included) into
each slot.
•Make sure to check the polarity. It is
written on the metal part of the battery
compartment cover.
•Close the cover.
HOW TO SET UP THE CAMERA
•Insert a microSD (not included) into the
slot.
•Insert the batteries or connect the micro-
USB cable to power supply at the bottom of
the camera –use the rubber cover.
•Use the included strap to fasten the camera
to a desired location.
•Turn the camera ON using the ON/OFF
switch.
•The camera will take 3 pictures and record
10 seconds of video each time the sensors
detect movement in the detection range.
•It enters standby mode until the next time
the sensor detects movement. It can
remain in standby mode up to 12 months.
•To set the time and date of the recordings,
open a text file on your computer and write
the current date and time in it in the
following format: 2020-11-11 12:59:59
332Y. Name the file time.txt and save it to
the microSD card that you will use with the
camera.
WARNINGS
•Only use the product for its intended
purpose.
•Do not disassemble or modify in any way.
•The product can only operate in
temperatures from -10 to 70 °C.