INSTRUCTIONS
ANGLE DRILLING TOOL KIT
ANGLEMASTER
PACKAGE CONTENTS
•1× drill guide
•3× drill bit (Ø 6, 8, 10 mm)
•3× stop collar (Ø 6, 8, 10 mm)
•6× sleeve (Ø6, 8, 10 mm)
•1× hex wrench
TECHNICAL SPECIFICATIONS
•Material: aluminum alloy, steel
•Drill-bit diameter: 6, 8, and 10 mm
•Drill-bit length: 94, 112, and 120 mm
•Drill-guide dimensions: 67 × 38 × 18 mm
COMPONENTS
(1) Drill bit
(2) Stop collar
(3) Drill guide
(4) Sleeve
(5) Hex wrench
USAGE
•Choose the required sleeves (4) for the hole
diameter you want to drill and screw them
on the drill guide (3).
•Center the drill guide on the workpiece and
secure it with a clamp (not included).
•Choose the required drill bit (1).
•Determine the hole depth you want to drill
and position the stop collar (2) at the drill
bit's correct length. Use the included hex
wrench to tighten the stop collar.
•Insert the drill bit into your power drill and
drill the pocket hole(s) until the stop collar
hits the metal sleeve on the top of the drill
guide.
•For cleaner holes and easier drilling, do not
attempt to drill the entire depth with one
stroke. Instead, use short strokes until the
drill has reached its final depth.
•Unclamp the drill guide from the workpiece.
•The pocket holes allow you to insert screws
(not included) through the workpiece to
another board.
WARNINGS
•Only use the products for their intended use.
•Before use, consult the user manual and
follow all steps to ensure safe operation.
•Make sure that the item is safely installed
and fastened before use.
•Only use the products with a proper machine
or attachment (electric drill).
•While using this item, make sure that others
are at a safe distance.
•Keep your work area well-lit and clean.
•Wear protective equipment during use
(protective gloves, mask, eye protection,
and ear protection) to ensure your safety.
•For additional usage information, read your
drill’s user manual.