1. Specifications
Power:
12 VDC @ 400 mA max from included desktop style 100-240 VAC input 12 VDC
output supply.
Size:
Wall Mount Version -1.7”Hx 9.9”W x 0.7”D
Rack Mount Version -1.74”Hx 19.0”W x 1.825”D
Weight:
1 lb including external power supply
Connectors:
(2) RJ45 connectors -one side entry connector and one rear entry connector wired in
parallel
Cable Requirements:
Maximum recommended resistance for the power or the control signal leads is 30
ohms. Higher resistances will result in diminished LED brightness.
Leads Supported:
Pins 4 or 5 -connect either or both pins 4 & 5 to the positive output of the 12 VDC
power supply to provide a source of power to the sign.
Pins 1 or 2 -connect either or both pins 1 & 2 to the power supply ground to cause the
word "SECURE" to illuminate.
Pins 3 or 6 -connect either or both pins 3 & 6 to the power supply ground to cause the
word "NONSECURE" to illuminate.
Note: Using 2 leads and/or heavier gauge wires for the power & control signals
reduces the resistance of the interconnect cable, allowing the sign to be located
further from the SecureSwitch.
2. Introduction
The SECURE/NONSECURE LED sign provides a means of displaying the security level
of a video teleconference or similar session. It is designed to connect directly to the status
output dry contact closure interface on the revision B and revision C SecureSwitch
products, or it can be controlled via dry contact closures from a programmable controller
or other device. RJ45 connectors on the side of the sign and on the rear of the sign are
wired in parallel, and are used to supply the power and control signals needed to operate
the sign.
3. Installation& Operation
The SECURE/NONSECURE LED sign has been designed to be mounted to any flat
surface. If mounting to a wall or similar surface, remove the 5 screws holding the front
panel to the enclosure. Using the provided dry wall anchors, secure the sign to the wall
thru the holes in the back of the sign enclosure, then reattach the front panel.
Alternatively, you can use the supplied Velcro tape to attach the sign directly to the front
of the SecureSwitch product or to other surfaces.
