Mart EQ-1 User manual

EQ-1 MAINTENANCE
Preventative Maintenance
The MART Corporation recommends that a preventative maintenance schedule be
established for processing the wastewater. More frequent processing shortens the
treatment time and the reduces the dosage rate of the Magic Dust. A good starting
point to determine frequency is to treat the solution after one week of use. If this
processing proves successful, try treating after two weeks and continue extending the
time between treatments to determine the best treatment frequency. Note that, if the
reservoir is allowed to become too saturated with contaminants, the treatment process
will become difficult or even impossible.
Service Schedule
The only servicing to the MART EQ-1
Processor is a thorough washdown after each
use. The Processor has a built-in rinse system
to facilitate the wash down procedure. It is
important to periodically remove the secured
cover on the upper Reactor Tank for inspection
and cleaning as necessary.
Empty and rinse the Processor after each use.
Never leave solution in the Processor for
extended periods. Aggressive chemicals can
damage the finish and corrode the tanks. Clean
the Sight Tube with the Sight Tube Brush
provided with the EQ-1 Processing System.
S
Sight tube & Brush
For Maintenance and Servicing of the EQ-1 Sump Pump and Mixer, refer
to the vendor-supplied operating manuals or speak with a MART Service
Technician at 1-800-567-6278.

EQ-1 TROUBLESHOOTING
Problem Solution
Mixer will not start. 1. Check electrical connections.
2. Unplug unit from electrical receptacle and check power cord
GFI unit. Press “RESET” button.
3. Check Fuses for continuity.
4. Check timer settings.
Sump Pump will not
start. 1. Check electrical connections. 2. Verify that solution is in Holding Tank.
3. Check that Sump Pump Float Switch is not sticking.
Filter paper clogging. Pull forward and roll up used portion of Filter Paper so fresh clean
paper is on the Platen.
Filter paper tears. Too much waste material on filter paper will cause paper to tear
from the weight of water and waste.
Reverse the Platen so that bottom side faces upward. Reposition
the Filter Paper to extend beyond the Platen on all sides.
No floc, or very little
floc, or pin floc. 1. Verify that the specified Magic Dust compound is being used. 2. Verify that correct amount of Magic Dust is being used.
3. Add more Magic Dust.
4. Shorten Mix time. A long mix time may chew up the floc.
5. Verify that processing instructions in Manual are being followed.
Mixer Pump vibrates
while running. 1. Unplug electrical connection. Process wastewater to empty Reactor Tank. Remove top cover. Inspect Propeller Blades and
remove any dried waste from Blades.
2. Rotate by hand to inspect motor shaft for straightness.
For technical assistance please contact:
MART Tech Services
2450 Adie Road, St. Louis MO 63043
Phone: [phone]-MART (314-543-6278)
1-314-567-7222 in Missouri
FAX: [phone]
Web: www.marttechservices.com
Email: [email protected]
2