Max Burton OVEN TO GO 6910 User manual

OVEN TO GO #6910
IMPORTANT SAFEGUARDS
Read all instructions before operating this or any electrical appliance
• Do Not touch hot surfaces
• Do Not immerse cord or unit in water or other liquids
• Do Not microwave or clean using a dishwasher
• Do Not use any accessory attachments with this product
• Do Not let cord hang over edge of table or counter
• Do Not clean with metal scouring pads
• Unplug when not in use and before cleaning
• Allow unit to cool before storing
• Keep cord away from hot surfaces
• Administer close supervision when running this appliance around children
• This appliance will not shut off automatically. Turn off immediately after use.
• Use caution when using in a moving vehicle
Warning: This product is designed to get hot very quickly and reach temperatures of 280ºF. Handle with
care. It will remain hot for a significant period after it has been unplugged. Aervoe is not responsible for any
damage caused by use or misuse of this product either intentional or accidental.
PARTS IDENTIFICATION
OPERATING INSTRUCTIONS
1. Remove the 12-volt plug and cord from its compartment
2. Place the oven on a horizontal surface. Be sure that the bottom of the oven is not touching plastic,
vinyl, or any other non-heat-resistant material.
3. Make sure the ON/OFF switch is in the OFF position. Place the plug into the 12-volt receptacle of the
vehicle.
4. Remove the outside packaging of the food and place inside of the included foil container(s). Place
container(s) of food inside of the oven and close the door.
5. Set the HI/LO switch to the desired heat level.
6. Turn the ON/OFF switch to ON to begin the warming process.
7. Cooking time will depend on the food being cooked. Occasionally check to see if the desired
temperature has been reached.
8. Remove container(s) with an oven-safe pad. Avoid putting hands in the oven when it is hot.
9. Turn the oven off when finished.
OPERATION IN VEHICLES
• Only operate while the vehicle’s engine is running.
• Make sure that your battery is strong and in good working condition before plugging your appliance
into your vehicle’s 12-volt receptacle.
• Do not use the unit if your vehicle’s electrical system is weak or damaged.
• Periodically check your vehicle’s charging system for continued successful use.
CLEANING
1. To clean oven, wipe inside and outside surfaces with a clean, damp cloth.
2. DO NOT immerse the oven in water.
3. DO NOT use solvents or harsh chemicals to clean oven. Use of solvents and/or chemicals may cause
damage to the oven surface.
TROUBLESHOOTING
If the 12-volt circuit fails to operate, try the following suggestions:
1. In the event that the unit does not appear to heat properly, unplug it from the power supply and make
sure that the receptacle is clean. Also check the vehicle’s fuse.
2. Be sure the contact points in the lighter receptacle are clean. DO NOT USE METAL TOOLS. Use only
insulators, such as wood, if cleaning is needed. The adapter plug should fit firmly in the receptacle.
3. Carefully unscrew the plug’s 12-volt top section. Remove and check the fuse with the proper electronic
meter. If defective, replace the fuse with a 15 amp-FI5A2500, 250 volt rated fuse. This fuse is readily
available at local auto parts and electronic stores.
4. Check your vehicle’s fuse panel to be certain that the fuse controlling the 12-volt receptacle is not
worn or weak. Replace a damaged fuse with a new properly sized and rated fuse to ensure satisfactory
performance.
5. Some 12-volt receptacles have a separate circuit breaker located directly behind the receptacle. If your
outlet is not working, this circuit breaker may have blown and could require replacement. Consult your
vehicle owner’s manual for replacement.
Handle
On/Off
Lo/Hi
Switches
12V Power
Cord & Plug
Oven Door
Oven Compartment
Foil Containers

OPERATING INSTRUCTIONS
TECHNICAL INFORMATION
SPECIFICATIONS
POWER SOURCE 12-Volt
OUTPUT Hi - 120W
Lo - 60W
POWER REQUIREMENTS 12-14V DC/100W
FUSE 250V DC/15A glass tube FI5A2500
LOW SETTING 140ºF - 175ºF measured at the heat plate
HIGH SETTING 240ºF - 280ºF measured at the heat plate
WEIGHT 3.75 lbs (1.7kg)
DIMENSION 10.5” x 8” x 4.5” (27 x 20 x 11cm)
FOIL CONTAINER SIZE 7” x 4.5” x 1.5” (18 x 115 x 38cm) 0.09mm thick
AERVOE INDUSTRIES, INC.
Gardnerville, NV 89410 • 1-800-227-0196
www.aervoe.com • [email protected]
6910inst; cs4/14
Oven To Go™
Max Burton is a registered trademark of Aervoe Industries, Inc.