Maxgear B1050 User manual

Adjustable Dual Monitor Stand (Black)
Product Description
Product Accessories
MG a er
ax
Product Name: Adjustable Dual Monitor Stand (Black)
33.8 x 11.9 x 5.2 inches
1 Pack
High Impact Polystyrene
Size:
Quantity:
Material:
[email protected]
35 mm
BX24
17 mm
28 mm
CX8
23 mm
DX1
17 mm
28 mm
426 mm 304 mm
222 mm
EX4
33 mm
AX8
42 mm
1

Installation Steps
Mode A
Install the products according to the instructions, and you can get
two monitor stands.
Insert the drawer partition into the
drawer. (Pay attention to align
with the slot in the drawer)
2
Install the accessories in the
corresponding position as shown in
the figure. (The height of the product
can be changed by adjusting the
number of B modules)
1
A
B
C
E
E
2

Adjust the angle according to your actual needs. (Angle range: 0°-180°)
0° - 180°
2
Mode B
Replace two B modules with one D module. (The D module can be installed
at the front or after side)
1
D
3

Complete the installation, you can get the monitor stand with different heights.
Attention: This installation method may cause a slight inclination on the higher
side. Don't place the monitor or printer on the higher side.
2
Mode C
Insert the B module into the hole on the top of another monitor stand.
1
B
4
（Pay attention to the green description text at the bottom of step 2）

Let the side with drawer facing the outside, you can get a monitor stand with
larger area.
2
Mode D
Install the D module on the after side of the dual monitor stand and rotate the
stand on the both sides.
1
D
5

When finish installation, you can get a monitor stand with 2 drawers. (The height
of the product can be changed by adjusting the number of B modules)
2
Mode E
Install one of the stands above the other one.
1
6