MBQ BK-60 User manual

Bass Reflex Ported Subwoofer with Built-in Amplifier
BK-80
Thank you for your concern about the use of this product, please read the instruction carefully before using this product.
BK-60
www.mbqaudio.com

This product provides two types of signal input methods. Please choose only one method to
connect the subwoofer. Never use both methods at the same time. Improper operation may
lead to damages or accidents.
LPFBASS BOOST
GAIN
PHASE
20~150Hz
180W
Impedance
Frequency Response
RMS. Output Power
Max Output Power. 280W
86dB
Сlass D
Built-in Amplifier Type
RCA input 04V.
Speaker input 1.0V
Input Sensitivity
10V~14.4V
Source Voltage
Weight(without accessories) 7 25Kg.
Phase Switch 0 / 180
Sensitivity(1W/1m)
Size(LxWxH) 452x201x2 09mm
4 + 4
Subwoofer Unit 6.5 inch 8 inch
200W
380W
11Kg
488x251x2 60mm
Model BK-60 BK-80
Technical Specifications

BK-60
BK-80
Dimensions
452mm201mm
209mm
488mm251mm
260mm

Accessories
Remote Controller x1
Screws(M3x6) x2
Fastener Tapes x2
Mounting Brackets x4
Screws(M4x20) x4 Screws(M5x10) x4
DC Cord x1 Wiring Harness x1
Cable Holder Bar x1
Installation Guide
Installation Guide
1. Decide where to install the subwoofer. Choose between using the fastener tapes and
using the mounting brackets. Simply tape the subwoofer to the floor when choosing it.
Or read the following guide to use the brackets.
2. Use four (M5x10) screws to fix the attached mounting brackets to the bottom of the
subwoofer.
3. Mark the tapping screws' postion on the floor.
4. Drill the holes and fix the subwoofer to the car using four (M4x20) screws.