MBS PS375 Instruction sheet

Address: Htm-Mbs
6420 Benjamin Rd,
Tampa, FL. 33634
Always check the installation surface
to ensure that the substrate will be
strong enough to hold the weight of
the panel. All installation must be
done so with proper hardware and
protective gears to ensure safety. It
is important to check that parts are
properly tightened at the end of each
installation.
3 Using the included tool, drive
your hanger screws into the nylon
anchors, then tighten barrels to
surface.
4 Screw threaded studs into your
barrels, then place your panel in
position and thread on caps until
snug.
1 Use the holes in your material
as a template to mark holes on
your mounting surface.
Installation Guidelines
Projecting Systems
Installation Tips
Phone : [phone]
Fax : [phone]
Mail: sales@mbs-standoffs
Hanger Bolt
Body
M6x8 with PE cap
2 Pre-drill 1/4" holes in your
surface, then insert nylon
anchors into the holes and tap
them flush.

2 Pre-drill 1/4" holes in your
surface, then insert nylon
anchors into the holes and tap
them flush.
Address: Htm-Mbs
6420 Benjamin Rd,
Tampa, FL. 33634
Always check the installation surface
to ensure that the substrate will be
strong enough to hold the weight of
the panel. All installation must be
done so with proper hardware and
protective gears to ensure safety. It
is important to check that parts are
properly tightened at the end of each
installation.
3 Using the included tool, drive
your hanger screws into the nylon
anchors, then tighten barrels to
surface.
4 Screw threaded studs into your
barrels, then place your panel in
position and thread on caps until
snug.
1 Use the holes in your material
as a template to mark holes on
your mounting surface.
Installation Guidelines
Projecting Systems
Installation Tips
Phone : [phone]
Fax : [phone]
Mail: sales@mbs-standoffs
Hanger Bolt
Body
M6x8 with PE cap
Washer