MD SPORTS LWN500 047M User manual

Assembly Instructions
MODEL
LWN500_047M
www.medalsports.com877-472-4296

English
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
LIMITED 90 DAYS WARRANTY
MD SPORTS
877-472-4296
LWN500_047M 1(Continued on the next page.) www.medalsports.com
www.medalsports.com
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP

English
1. Please do not sit, climb or lean on the product.
2. Adult supervision is required for children playing this game.
Adult assembly required.
CHOKING HAZARD - This item contains small parts. Not suitable for children under 3 years.
WARNING
Keep away from pets in
assembly area
No Children in
Assembly Area
English
LWN500_047M 2(Continued on the next page) www.medalsports.com
IMPORTANT NOTICE

Leg
1
x6
FOR FIG. 2
PART NUMBER FIG. NUMBER
QUANTITY
PART
PART NAME
Pocket
2
x2
FOR FIG. 3
Large Curved Pole
3
x6
FOR FIG. 3
Small Curved Pole - A
4
x2
FOR FIG. 1
Small Curved Pole - B
5
x4
FOR FIG. 1
3 Way Connector
6
x6
FOR FIG. 1
Leg Cap - Round
7
x6
FOR FIG. 2
Leg Cap - Stake
8
x6
Mesh Netting
9
x2
FOR FIG. 5
Carry Bag
12
x1
ACCESSORIES
Bottom Pole
P1
x6
FOR FIG. 2
Top Pole
P2
x6
FOR FIG. 2
4 Way Connector
P3
x6
FOR FIG. 2
PRE-INSTALLED PARTS
BEFORE ASSEMBLY
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list page. If any parts are missing, call our customer service.
1.
2.
Flying Disc - Red
10
x2
Flying Disc - Blue
11
x2
English
PARTS IDENTIFIER
LWN500_047M 3(Continued on the next page) www.medalsports.com

FIG. 1
x2
4
x4
5
x6
6
FIG. 2
1
Pre-installed
x6
x6
P1
Pre-installed
Pre-installed
x6
P2
x6
P3
x6
7
Keep Pin
Locks open
1
P3
Note: Insert the bottom pole (P1) into the
leg cap (7). repeat for all 3 legs.
P1
P2
P2
P1
7
Close Pin Locks
P3
English
ASSEMBLY
LWN500_047M 4(Continued on the next page) www.medalsports.com
P1
1
5
6
6
Note: Connect the small curved poles (4 & 5)
into the 3 way connectors (6).
5
4
6
5
4

English
ASSEMBLY
LWN500_047M 5(Continued on the next page) www.medalsports.com
FIG. 3
2
x6
x2
3
Note: Make sure that all connectors are correct.
FIG. 1 Assembly
Note: Next insert the top pole
(P2) into the top connector
of FIG. 1 Assembly. Repeat for
all 3 legs.
6
P2
FIG. 2 Assembly
2
Note: Slide large poles (3) through the
mesh pocket sleeves (2), then insert the
large poles (3) into the 4 way connectors
(P3). Repeat for all 3 sides.Repeat for all
3 legs.
2
3
Sleeves
3P3
P1
P2
P1
P2

FIG. 4
FIG. 5
FIG. 3 Assembly
Note: Turn over the
FIG. 3 Assembly.
9x2
English
ASSEMBLY
LWN500_047M 6(Continued on the next page) www.medalsports.com
9
Note: Insert the knots of the
mesh netting (9) through the
holes of the 3 way connectors
(6). Repeat for all 3 sides.
knot
6

English
HEIGHT ADJUSTMENT
LWN500_047M 7(Continued on the next page) www.medalsports.com
Keep Pin
Locks open
P1
P1
P1
Close Pin Locks

English
LEG CAP EXCHANGE
LWN500_047M 8(Continued on the next page) www.medalsports.com
10
11
Note: Place the poles, Connectors, Leg caps, mesh
netting and mesh pockets into the carry bag. Then
place the discs into the front pocket and Go!
12
10
x2
x1
x2
11
12
EASY STORAGE
Note: Round leg caps are for indoor & pavement use. Note: Stakes leg cap are for on grass use.
P1
7
8
P1

English
FLYING DISC RULES
LWN500_047M 9(The last page) www.medalsports.com
THE GAME
Disc Golf is played like traditional golf but by throwing flying discs instead of hitting a ball with a club. Each time you
throw the disc it counts as one point. The object of the game is to land your disc in the target with the least number of
throws or points.
Set up your targets and determine a starting point or tee off point for each target. Determine if there are any areas
around the play area that should be designated as out of bounds, such as over a fence or a roadway. Decide the number
of “holes” to be played. Selecting multiple starting points for each target is one way to increase the number of holes for
your game. You can play as many holes as you want, or you can play 9 or 18 holes like traditional golf. Choose a player to
start the game using a coin toss. Each player then throws his or her driver disc at the target, from the designated tee off
place. Be sure to mark where your disc lands as that is the place where you will throw from on your next turn. The player
whose disc is farthest away from the target will begin the next round of throws. The next farthest from the target goes
second and so on, until all players have thrown their discs again. Continue in this pattern until all players have landed
their discs in the target. When you get close to the target, switch to the putting disc to finish the hole. The disc must land
inside the target to complete the hole. A disc that lands next to the target or on top of it does not count. If a disc lands
on top of an obstacle in your play area, you will throw from the closest possible spot on the ground. If a disc lands in an
area designated as out of bounds, you will throw from a place that is perpendicular to where the disc landed and the
out of bounds line, within 3 feet of the out of bounds line. Keep track of the number of throws each player takes to finish
the hole. After all players have gotten their discs into the target, proceed to the next tee off point and begin the next
round. The player with the least number of throws, will be the first to play in the next round. When all players have
completed each hole, the player with the lowest total score wins the game.

www.medalsports.com