Prodigy T1 User manual

Thank you for choosing Prodigy Disc for
your Professional Disc Golf Targets!
Our targets are used for Pro Tour and Disc Golf Major
Championships. Prodigy Targets are preferred by top
Professionals and world class courses.
Dimentions:
56 inches tall
22 inches around the top
THE TARGET
THE SPECS
10 inches wide x 36 inches deep
This is required for the install of the
ground sleeve and concrete.
THE HOLE
• Concrete
• Fill Dirt
• Gravel
• Duct Tape
MATERIALS YOU’LL NEED
THE GOODS
• Level • Shovel
• Tape Measure • Tamper
• Auger or Post Hole Digger
RECOMMENDED TOOLS
PRODIGY TARGET INSTALLATION GUIDE

INSTALLING A TARGET
THE HOW-TO
Dig a Hole.
10 inches wide x 36 inches deep. (48 inches in
colder climates.)
Fill the bottom 12 inches (24 inches in colder
climates) with ¾ clear gravel and tamp.
1
Place the ground sleeve in the
ground to check for depth.
Aim for the top of the sleeve to be 2″ above
ground level. This allows for easy access to the
lock. Remove the ground sleeve after inspecting
the depth.
2
Fill hole with concrete mix.
Keep in mind to leave enough space under the
lock loop to allow for easy access of the lock.
3
Seal the bottom of the sleeve
with duct tape and place it into
the wet concrete.
Ensure that the sleeve reaches the bottom of
the hole and concrete does not get inside the
sleeve.
4
Using a level, check that the
ground sleeve is level in the
concrete.
To do this, insert pole into sleeve and put level
on the pole.
5
Allow time for the concrete to
dry with the sleeve.
6
PRODIGY TARGET INSTALLATION GUIDE
Install basket, apply lock, and
add backfill dirt into the hole.
7