MD SPORTS TT415Y21006 User manual

NEW!
Follow along with your smartphone
to make assembly even easier!
MODEL
TT415Y21006
www.medalsports.com877-472-4296
Assembly Instructions
Menards

FOR A QUICKER & EASIER
ASSEMBLY EXPERIENCE
Before you begin
Step 1: Scan the QR code below and download the free BILT app.
Step 2: Once in the BILT app, Scan the QR code below again to get MD SPORTS
products and find the models you need.
Step 3: Begin the easy assembly of this product by using the BILT 3D-guided interactive
instructions.

English
LIMITED 90 DAYS WARRANTY
TT415Y21006 1(Continued on the next page) www.medalsports.com
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
MD SPORTS
877-472-4296
www.medalsports.com
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP

English
TOOLS REQUIRED
IMPORTANT NOTICE
Adult assembly required.
CHOKING HAZARD - This item contains small parts and small balls. Not suitable for children under 3 years.
WARNING
TT415Y21006 www.medalsports.com2(Continued on the next page)
X2
At least 2 adults needed No children in assembly
area
Keep away from pets in
assembly area
Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
This product is intended for INDOOR use only.
Please do not sit, climb or lean on the product.
Please do not drag the product when moving it in order to avoid damaging the legs.
Please only use furniture polish spray to clean the exterior surfaces of the product.
This is not a children's toy, adult supervision is required for children playing this game.
1.
2.
3.
4.
5.
- Not Included
- Not Included
- Included
- Included
RECOMMENDED
Phillips Screwdriver
Standard (Flat Head Screwdriver)
Wrench
Allen Key
Electric Screwdrivers may be helpful during assembly; however, please set a low
torque and use extreme caution.
Power Tools: Set to Low Torque
High Torque Over Tightened

Bracket
17
x6
FOR FIG. 2
Wood
Block Spacers
18
x2
FOR FIG. 16
Corner Cap
19
x4
FOR FIG. 8, 14
Safety
Strap - Short
14
x2
FOR FIG. 3 15
x8
FOR FIG. 4, 10
Leg Bracket - BLeg Bracket - A
16
x4
FOR FIG. 5, 11
Leg Panel
9
x2
FOR FIG. 17
Table Lock
10
x2
FOR FIG. 19
Net
11
x1
FOR FIG . 22
Net Post
12
x2
FOR FIG . 22
End Apron
(1.35m)
5
x2
FOR FIG. 9, 15
Safety
Strap - Long
13
x1
FOR FIG. 3
Side Apron
(1.25m)
6
x4
FOR FIG. 9, 15
Linkage Tube
with Stop Bracket
7
x2
FOR FIG. 6, 12
Linkage Tube
8
x2
FOR FIG. 7, 13
Table Surface - 2
2
x2
FOR FIG. 1
Outer Leg
with Caps
3
x2
FOR FIG. 4, 10
Inner Leg
with Caps
4
x2
FOR FIG. 4, 10
Table Surface - 1
1
x2
FOR FIG. 1
PART NUMBER FIG NUMBER
QUANTITY
PART
PART NAME
TT415Y21006 www.medalsports.com3(Continued on the next page.)
English
PARTS IDENTIFIER
HARDWARE
Table Tennis
Ball
21
x2
Table Tennis
Paddle
20
x2
Table Cover
22
x1

TT415Y21006 www.medalsports.com4(Continued on the next page.)
English
HARDWARE
x88
x4
x8
Wrench
A1
x1
Allen Key
A2
x1
M6x50mm Bolt
A3
x10
FOR FIG. 6, 7, 12, 13, 19
M6 Washer
A5
x28
FOR FIG. 6, 7, 12, 13, 17, 19
M6 Nut
A7
x10
FOR FIG. 6, 7, 12, 13, 19
FOR FIG. 17 FOR FIG. 17
M5x12mm Screw
A8 FOR FIG. 2, 4, 5, 10, 11
Bushing
A6
x8
FOR FIG. 6, 7, 12, 13
“U” Bolt
A4 FOR FIG. 17
M4x12mm Screw
A9
x47
FOR FIG. 3, 8, 9, 14, 15 FOR FIG. 19
Spring Lock
Washer
A11
x8
“T” Washer
A10
x2
Wing Nut
A12
PRE-INSTALLED PARTS
Outer Leg Cap
P1
x4
FOR FIG. 4, 10
Inner Leg Cap
P2
x4
FOR FIG. 4, 10
Wheel
P3
x4
FOR FIG. 4, 10
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list pages. If any parts are missing, call our customer service.
1.
2.
BEFORE ASSEMBLY

FIG. 1
x2
1
x2
2
2
2
Note: The playing surface should face
down when assembling.
1
1
Player End
Player End
Player End
Center End
Center End
ASSEMBLY
TT415Y21006 www.medalsports.com5(Continued on the next page.)
English

FIG. 2
x6
17
x24
A8
Note: Each table section has pre-drilled holes
on the inside of each section. The table top
section (1 & 2) will line up next to each other.
The bracket (17) will match the pre-drilled
holes as shown in FIG. 2.
2
1
Player End
Center End
17
17
A8
2
1
17
A8
2
17
1
2
1
Player End
17
17
ASSEMBLY
TT415Y21006 www.medalsports.com6(Continued on the next page.)
English

FIG. 3
x1
13
x2
14
x3
A9
Pre-installed
x2
x2
P2
Pre-installed
P3
Pre-installed
x2
P1
FIG. 4
x1
3
x4
15
x24
A8
x1
4
Note: The notch of leg bracket A (15) will face
toward the center end of the table.
15
15
3
4
15
A8
Player End
Center End
P1
P3
P2
A9
14
2
2
1
1
14
13
A9
ASSEMBLY
TT415Y21006 www.medalsports.com7(Continued on the next page.)
English

FIG. 6
x1
7
x2
A3
x4
A5
x2
A6
x2
A7
x1
A1
x1
A2
FIG. 5
x2
16
x8
A8
16
16
A8
7
7
4
3
A7
A6
A5
A5 A3
Note: The linkage tube with stop bracket (7)
connects to the Inner Leg (4) from the outside,
and the Outer Leg (3) from the inside.
ASSEMBLY
TT415Y21006 www.medalsports.com8(Continued on the next page.)
English

FIG. 8
x2
19
x6
A9
FIG. 7
x1
8
x2
A3
x4
A5
x2
A6
x2
A7
x1
A1
x1
A2
Note: The linkage tube (8) connects
to the Inner Leg (4) from the outside,
and the Outer Leg (3) from the inside.
4
3A6
8
A5
A3 A7
A5
8
A9
19
A9
19
ASSEMBLY
TT415Y21006 www.medalsports.com9(Continued on the next page.)
English

FIG. 9
x1
5
x2
6
x16
A9
6
6
5
A9
Pre-installed
x2
x2
P2
Pre-installed
P3
Pre-installed
x2
P1
FIG. 10
x1
3
x4
15
x24
A8
x1
4
4
15
15
3
Player End
Center End
P1
15
A8
P3
P2
Note: The notch of leg bracket A
(15) will face toward the center
end of the table.
ASSEMBLY
TT415Y21006 www.medalsports.com10(Continued on the next page.)
English

FIG. 11
x2
16
x8
A8
A3 A5
A6
A7
4
7
3
A5
7
Note: The linkage tube with stop bracket
(7) connects to the Inner Leg (4) from the
outside, and the Outer Leg (3) from the
inside.
FIG. 12
x1
7
x2
A3
x4
A5
x2
A6
x2
A7
x1
A1
x1
A2
16
16
A8
ASSEMBLY
TT415Y21006 www.medalsports.com11(Continued on the next page.)
English

FIG. 13
x1
8
x2
A3
x4
A5
x2
A6
x2
A7
x1
A1
x1
A2
8
A5
A7
A6 A5
4
8
3
A3
Note: The linkage tube (8) connects to the Inner
Leg (4) from the outside, and the Outer Leg (3)
from the inside.
FIG. 14
x2
19
x6
A9
19
A9
19
ASSEMBLY
TT415Y21006 www.medalsports.com12(Continued on the next page.)
English

FIG. 16
x2
18
Note: Use the wood block spacers to
align the center gap before assembling
the leg panel.
18
FIG. 15
x1
5
x2
6
x16
A9
6
5
6
A9
18
ASSEMBLY
TT415Y21006 www.medalsports.com13(Continued on the next page.)
English

9
9
FIG. 17
x2
9
x4
A4
x8
A5
x8
A11
x8
A12
Note: Both leg panels should be inverted when
assembling.
9
9
9
A4
A12
A5
A11
ASSEMBLY
TT415Y21006 www.medalsports.com14(Continued on the next page.)
English

DO NOT lean too much weight on
the wheels while lifting the table.
Lift the table.
Fold the table.
Two adults required. Hold up the table on its side.
Make sure to buckle
the Safety Straps.
Lock Wheels.
13
14
FIG. 18
FIG. 18A
FIG. 18C
FIG. 18E
FIG. 18B
FIG. 18D
FIG. 18F
ASSEMBLY
TT415Y21006 www.medalsports.com15(Continued on the next page.)
English

14 13
Note: Unbuckle the Safety Strap before
unfolding the table.
FIG. 20
FIG. 19
x2
10
x1
A1
x1
A2
x2
A10
x4
A5
x2
A7
4
10
A7A5A10A5
4
A3
10
Note: Install the Table Lock accordingly.
10
10
ASSEMBLY
TT415Y21006 www.medalsports.com16(Continued on the next page.)
English
x2
A3

FIG. 21
Note: Pull the legs out from the table top and
lower the table half to the floor.
10
10
Note: Unlock the table locks.
ASSEMBLY
TT415Y21006 www.medalsports.com17(Continued on the next page.)
English

FIG. 22
x1
11
x2
12
12
Note: Attach the post and the net.
12
11
11
ASSEMBLY
TT415Y21006 www.medalsports.com18(Continued on the next page.)
English