MD SPORTS 1651610 User manual

MODEL: 1651610
Blain's
ASSEMBLY INSTRUCTIONS
TM
ATTENTION
DO NOT RETURN
TO THE STORE
Contact
MD Sports
Customer Service
* For additional resources and Frequently
Ask Questions, please visit us at
themdsports.com

LIMITED 90 DAYS WARRANTY
NOTICE!
STAPLE YOUR RECEIPT HERE
1 - Please leave your name, address, phone number, model number, parts needed on the answering
machine if there is no attendant. Failure to do so will result in a delay in shipping parts to you.
www.themdsports.com
1651610 1
(Continued on the next page.)
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If,
during the limited warranty period, a part is found to be defective or breaks, we will offer replacement
parts at no cost to you, the customer. The only exceptions to the warranty include mainframes, table tops,
playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse,
accidental damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights which vary from
one State (province) to another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is
initiated. For all requests for warranty service, please feel free to contact our Consumer Service
Department at :
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal
Sports, can not handle the product which is out of product’s limited warranty since we only provide available
parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING
THE PRODUCT TO THE STORE.
WEBSITE: www.themdsports.com

CAUTION !
ASSEMBLY TIPS
WARNING:


WARNING: Adult Assembly Required.
IMPORTANT NOTICE!
No Children in
Assembly Area
Keep away from pets Do not use or keep product
outdoors. For indoor use only.
No wet/humid conditions.
1 - Please read the instructions carefully, and follow all assembly, operation and safety instructions
properly in order to avoid damage and injury. For the assembly, at least two adults are required.
2 - Some figures or drawings may not look exactly like your product. Please read and understand
the text before beginning each assembly step.
1 - This product is intended for INDOOR use only.
2 - Please do not sit, climb or lean on the product.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
www.themdsports.com
1651610 2
(Continued on the next page.)

WARNING
●Product must be assembled by an adult before use.
●Do not over-inflate.
●Not to be used as a floating device.
●This product is for youth use only; it is not intended for adult training
Child Safety
● Not to be used by children without adult supervision.
●To reduce the risk of suffocation, drowning or serious personal injury,
- Adults must always stay within reach of children while playing.
- Keep product away from small children when it is not inflated.
Product Protection
●Play only in an open area away from sharp objects, with at least a clear space of 3m around the
product.
●Avoid contacting the inflatable bag with sharp objects or hot surfaces which could cause injury to your
hands.
●Remove sharp objects from your body which could damage the product, such as rings, watches etc.
●Make sure that there are no sharp objects on your shoes which might cause damage to the product.
3m
Target Bag
3m
VINYL PATCH REPAIR TIPS
1. Cut the required size from the vinyl patch to fix any holes on the product (except a broken joint).
2. Clean the damaged surface and ensure it is dry.
3. Tear off the paper on the back of the vinyl patch.
4. Stick the vinyl patch firmly over the hole.
5. Do not inflate the product until the vinyl patch has been fixed in place for at least 20 minutes
SAFETY INSTRUCTIONS
www.themdsports.com
1651610 3
(Continued on the next page.)

1651610 PARTS LIST
Note:
1. Heavy duty inflatable bag with sensors (#1) is not available as a replacement part.
FIG.1
1. Fill the Base with water and then insert the Inlet Cover (P2) and Inlet Cap (P1). See FIG. 1.
ASSEMBLY INSTRUCTIONS:
Base Base
Fill the Base with
water.
P2
11
P1
WATER
www.themdsports.com
1651610 4
(Continued on the next page.)
FIG. 1
X 1
1
X 1
P1
X 1
P2
1651610 PRE-INSTALLED PARTS
2 31
x1 x1 x2
Inflatable bag with sensors LCD control box with belt
P2P1
x1 x1
Inlet Cap Inlet Cover
Vinyl Patch
ON/OFF
ON/OFF
RESET
VOLUME/SOUND
UP
DOWN
ENTER/SELECT

FIG. 3
3. Fasten the LCD control box on the neck. See FIG.3 .
FIG. 2
2. Inflate the Base, Target Bag and Neck sections with an air pump (not included). See FIG. 2.
Inflation
Cover nozzles
Cover nozzles
Target
Bag
Base Base
Target
Bag
DO NOT OVER
INFLATE
Neck Neck
1 1
1651610 5
(Continued on the next page.)
ON/OFF
ON/OFF
RESET
VOLUME/SOUND
UP
DOWN
ENTER/SELECT
ON/OFF
ON/OFF
RESET
VOLUME/SOUND
UP
DOWN
ENTER/SELECT
Connect the
electronic wire to the
LCD control box.
1
2
electronic wireelectronic wire
control boxcontrol box
14 pins14 pins
2
FIG. 3
X 1
2
ON/OFF
START/ENTER
UP/DOWN
SELECT
FIG. 2

WARNING:
!
1) Requires 3 “AAA” batteries (not included).
2) Do not mix old and new batteries.
3) Do not mix alkaline, standard (carbon zinc), or
rechargeable (nickel-cadmium) batteries.
1651610 6
(Continued on the next page.)
Battery Installation
1. Using a Phillips Head Screwdriver (not included), remove the battery box cover on the back of the control box
and install 3 new “AAA” batteries.
2.Replace the battery box cover using a Phillips Head Screwdriver (not included).
Reminder:
a. Batteries must be installed according to the correct polarization (+and -) required.
b. If the game will not be used for a long period of time, we recommend that the batteries should be removed.
c. Please clean the battery contacts and also those of the device prior to battery installation.
Electronic Scorer Operation and Game Installation
Game Instructions
1. Press the ON/OFF key to turn the power on.
2. Select the game mode by pressing the UP or DOWN keys. Choose “Training”, “KO” or “SpeedBag” modes.
3. Press SELECT/ENTER.
4. Press UP or DOWN to choose between Boxing, Kicking or Kick Boxing.
5. Press SELECT/ENTER.
6. Press UP or DOWN to choose a difficulty level, 1, 2 or 3.
7. Press SELECT/ENTER.
8. Press UP or DOWN to choose the time limit, from 1 to 5 minutes. The default is 3 minutes.
9. Press SELECT/ENTER.
10. The game begins after a 5 second countdown.
11. After each successful hit, the relevant light will flash.

YOU ARE NOW READY TO PLAY!
This device complies with the part 15 of the FCC
rules. Operation is subject to the following two
conditions :
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
1651610 7
(The last page)
12. At the end of the game, the LCD will display the result. Scores will be shown separately for HIT, MISS and
PERCENTAGE.
13. After the game is over, press SELECT/ENTER to restart the game (step 10).
14. In the “Speedbag” and “KO” game modes, after the game is over for Player 1 there will be a 5 second
countdown before the game commences for Player 2.
15. Pressing the RESET key for 1 seconds at any point will return to the game select mode (step 2).
NOTES:
1. Pressing the ON/OFF key at any point for one second will turn the game off.
2. After a 5 minute period of inactivity, the game will automatically power off. Pressing the ON/OFF key will return
the game to the previous position.
3. To adjust the volume, press the VOLUME SOUND ON/OFF key and the UP or DOWN keys to reach the
desired volume level. The volume levels range from 0 to 5, where 0 is mute and 5 is the maximum.