Micromega CD User manual

CD
OWNER’S MANUAL

Dear Customer,
Thank you for purchasing CD.
This unit provides ease of use and sonics of the highest quality. Please pay close attention to this instruction manual, and
read it fully before attempting to operate. It is designed to ensure that you maximise your pleasure of CD and familiarise
you with its many unique functions.
CHECKING
Check that the carton has no damage. Should you have any
doubt about its condition, please do not hesitate to contact your
dealer.
UNPACKING
Very carefully remove the unit from the box, taking care to
preserve all the packing material. It is good practice to put the
carton and its contents into an outer plastic bag and deposit it
somewhere safe and dry. In the unlikely event that your unit
needs to be sent back to either your dealer or distributor, it must
be sent in the original packing material. Failure to observe this
will invalidate your warranty.
ACCESSORIES
Upon opening the carton you should find the following:
 Mains Lead.
 Stereo Cinch cable
 Remote control Handset and 2x AAA batteries.
MAINS VOLTAGE
 Check that the mains voltage indicated on both the carton
and the rear of the unit correspond to the local power supply
If you are in any doubt, consult your dealer.
INSTALLATION
In order to obtain the maximum performance of CD, it is
important to follow the installation instructions.
Wherever possible, we recommend that CD is installed in an
audio rack or other suitable furniture that provides sufficient
ventilation.
CONNECTIONS
Having verified that the ON/OFF switch is on OFF position,
connect the mains leads provided to the rear of the unit and to
the wall socket.
Connect the interconnect cable from the rear of CD to your
amplifier input. Connect the Digital out if required.
POWER UP
You may now turn on CD by switching the ON/OFF switch
located at the back of the unit.
The central LED lights up indicating that the unit is in Standby
mode. Press once the CD key of the remote control or the
STANDBY key of the unit. The display indicates:
CD FRONT PANEL
 STAND-BY : To switch the unit in and out of Standby mode.
A red LED located below the central logo illuminates when in
Standby mode.
 MODE : To switch the Digital output on and off.
 NEXT/FFWD : Selection of the Next track and Forward
search during play.
 PREV/FREV : Selection of the Previous track and Reverse
search during play .
To replay the current track during play.
 PLAY/PAUSE : To start Play and to Pause during play.
 STOP/DISC : To Stop play, to clear a program in Stop mode
or to Open and Close the cd tray.
DISPLAY
The display indicates :
 On the left side track indication,.
 In the middle the status of the unit
 On the right side the time in minutes and seconds.

PLAY
 Press once the STOP/DISC key to open the tray.
After pressing the STOP/DISC key again the tray closes and the unit
reads the T.O.C. The display indicates:
 Press the PLAY/PAUSE key to start playing a disc. The display
indicates:
The display indicates the current track, Play mode and elapsed time.
If you wish to stop playing a disc, press STOP/DISC.
To eject the disc, press STOP/DISC while the unit in Stop mode.
 Press STANDBY to place the machine in Standby mode.
If the CD tray is pushed manually when a disc is loaded, it will begin to
play once the tray has closed ( AUTOPLAY ).
TRACK SELECTION ( 0-9)
 You may directly access any track by utilising the numeric keypad
of the remote control handset. ( Tracks with 2 digits should be keyed in
within 2 seconds )
 You may also use of the NEXT or PREV keys.
SEARCH
 Continual pressure on the PREV/FREV key will allow you to
search for a passage in reverse direction; continual pressure on the
NEXT/FFWD key will allow you to search for a passage in the forward
direction.
 The time that you continue to press the key determines the speed
of the search: for the first three seconds the output volume is reduced,
after three seconds the search speed is increased and the sound is
muted.
SCAN MODE ( SCAN )
 Press the SCAN key in either Stop or Play mode.
The display indicates:
 Should you find a track that you wish to play completely, press the
SCAN key again.
RANDOM MODE ( RANDOM )
 Press the RANDOM key before or during Play.
The display indicates:
 Press the RANDOM key to return to normal Play mode.
A/B REPEAT
 Press the A / B key while in play at the starting point of the
passage that you wish to repeat. The display indicates:
 Press again the A / B key at the final point of the passagethat you
wish to repeat. The display will then indicate:
 Press the A / B key to cancel the A/B mode.
REPEAT
 Press the REPEAT key before or during Play.
The display indicates that you are repeating the current track:
 Press the REPEAT key again and the display will indicatethat you
will be repeating the whole disc:
 Press the REPEAT key to cancel the Repeat mode.
TIME INFORMATION ( TIME )
 Press the TIME key if you wish to know the remaining time of the
playing track (REM TIME). The display indicates:
 Press the TIME key again during Play if you wish to know the
elapsed time since the beginning of the disc. (TOTAL TIME):
 Press the TIME key again if you wish to know the remaining time
on the disc. (TOTAL REM TIME):
 Press the TIME key again if you wish to return to default
(TRACK TIME).
DIGITAL OUPUT ( MODE )
You can activate the Digital output bypressing on the MODE key. This
is necessary if you wish to use a separate Digital to analog converter
or if you wish to make a Digital recording.
EITHER MODE WILL BE SHOWN ON THE DISPLAY FOR 2 SECONDS.
PROGRAMMING ( PROG. )
You may program a maximum of 20 tracks at any time.
 Select the number of the track that you desire to store by using the
numeric keypad ( 0-9 ) or by using the PREV/FREV or NEXT/FFWD
keys.
 Store your choice bypressing the PROG key.
Each time you store a track, the display will show the number of stored
tracks and the total time of this selection:
 Press the PLAY/PAUSE key to start playing your selection.
 When the selection has finished, press the STOP/DISC key again
to clear the selection:

MICROMEGA S.A. 4, rue Vermont, ZA des Boutries, 78700 Conflans Sainte Honorine FRANCE
TEL: [phone] FAX: [phone] INTERNET: http://www.micromega-hifi.com
CARACTERISTIQUES TECHNIQUES CD TECHNICAL CHARACTERISTICS
Caractéristiques Audio. Audio Characteristics
Bande Passante ( - 0.5dB )……………….DC –20Khz Bandwidth ( - 0.5dB )……………........... DC –20Khz
Linéarité à –90dB………………………………..0.5dB Linearity at –90dB…………………………….. 0.5dB
Rapport signal/bruit + THD …………… -96dB à1kHz Signal/noise ratio + THD …………….-96dB à1kHz
Diaphonie………………………………..100dB à 1kHz Crosstalk……………………………….100dB à 1kHz
Conversion numérique-analogique…….. 1 bit / 256 fs Digital to Analog conversion…………….1 bit / 256 fs
Impédance de Sortie …………………………….. 600 Output impedance ………………………………600 
Niveau de sortie ………………………….. 2Vrms / 0dB Output level ………………………………2Vrms / 0dB
Alimentation Power Supply
Consommation électrique : .........................…… 11 W Power consumption …………………………..…11 W
Fusible T 160mA / 250V (Temporisé) Fuse type T 160mA / 250V (Slow Blow)
T 315mA / 130V (Temporisé) T 315mA / 130V (Slow Blow)
Dimensions : ( L x P x H mm) ……….430 x 300 x 70 Dimensions : ( W x D x H mm)……. 430 x 300 x 70
Poids ……………………………………………… 4.0 kg Weight ………………………………………….. 4.0 kg
GARANTIE
Le lecteur CD est garanti 2 ans à partir de la date d’achat.
Si votre appareil nécessitait une intervention, vous devriez le ramener au revendeur auprès duquel vous aviez
effectué votre achat, dans son emballage d’origine accompagné de la facture d’achat.
La garantie couvre les vices de fabrication à l'exclusion de tout autre dommage tel que :
- Un accident
- Une négligence
- Une erreur de manipulation
- Une installation non conforme au présent manuel
- Une intervention effectuée par des gens inhabilités
- Les dégâts lors du transport ( Les dégâts ne seront pris en compte par le transporteur qu’à condition d’avoir émis
auprès de celui-ci les réserves d’usage lors de la livraison.)
ATTENTION : La garantie s’annule d’office si votre appareil n’est pas expédié dans son emballage d’origine
ou si le numéro de série a été effacé ou changé.
Certificat de Garantie Warranty Certificate Cachet du Revendeur Dealer's Stamp
N° de SER
IE
Serial NUMBER
Date d'Achat
Purchase Date