Mighton MigStop User manual

MigStop
Installation Instructions
The MigStop is easily fitted. Please read the instructions carefully before installation.
Pack contains parts for two sash windows.
Important: Consideration should be given before fitting to Egress windows. MigStop barrel is 20mm
long & 16mm in Diameter. This device must be fitted in a position that allows no more than a 100mm
restricted opening.
Ensure the sash is completely closed and locked before starting the installation.
Important!
Close and lock sash before starting installation.
Measure 100mm up from top of bottom sash
and mark window frame as shown above.
Drill a 10mm diameter hole 18mm deep
on the marked positions on the top sash.
Parts List
Installation
1 2
A4 x Insert Unit
B1 x Key
C4 x Strike Plates
D8 x Self Drilling Screws
E4 x Barrel Unit
100mm
C
D
B
E
A
“Make It Once...Make It Mighton...” www.mightonproducts.com

Using a 6mm Allen key, screw the Insert Unit(A)
into the holes on both sides of the top sash.
De-activate MigStop by
removing the Barrel Unit(E)
from Insert Unit(A) using the
key provided (B).
Verify device operates correctly and window opening cannot exceed 100mm.
Activate MigStop by attaching
Barrel Unit(E) into Insert Unit(A)
using the key (B) provided.
Attach Barrel Unit (E)into Insert Unit (A) using the
Key (B) provided and lower the sash. Install the
Strike Plate (C) where the Barrel Unit (E)meets
the meeting rail using the Screws (D) provided.
The window opening cannot
exceed 100mm.
Installation - continued
Operation
3 4
Clean the MigStop with a damp cloth. On a regular basis, ensure the device operates correctly.
Consideration should be given before fitting to Egress windows.
Please keep the key in a safe place.
“Make It Once...Make It Mighton...” www.mightonproducts.com
Mighton Products Ltd, Hinxton, Cambridgeshire CB10 1RG 01223 497097 [e-mail]
A
C
E
A
MAX
100mm
D
E
EA
A