Milwaukee 58-03-0020 User manual

1 Blue Cord 70mm As received, apply with #8.
2 Brown Cord 70mm As received, apply with #9.
3 White Field ----- As received.
4 Black Field ----- As received.
5 White Field ----- Strip 5mm for T1.
6 White Field ----- Strip 5mm for T1.
7 Green/Yellow Cord ----- Strip 5mm for T1.
DYMODRILL and SWITCH BOX 58-03-0020
DATE
Feb. 2011
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS. BULLETIN
WIRING INSTRUCTIONS
TITLE
Drwg. 2
CONNECTOR DESCRIPTION
NOTE:
All leads must be held to ± 1/8".
All lead lengths are before stripping.
TERMINAL DESCRIPTION
Part No.Code Qnty.
Terminals, Connectors and 1 or 2 End Wire Preparation
Wire
Color Origin or
Gauge
Wire
No. Length
WIRING SPECIFICATIONS
T1 23-74-0840 3

20 20
ITEM PART NUMBER DESCRIPTION QTY.
1 22-68-0200 SWITCH BOOT (Not Shown) (1)
2 23-66-1430 SWITCH - DELAY TYPE (1)
3 23-94-9915 LEADWIRE ASSEMBLY - RED (1)
4 22-36-0150 BREAKER (1)
5 22-68-0210 BREAKER BOOT (1)
6 22-33-0430 SUPPRESSOR (1)
7 22-74-0053 CURRENT LIMIT DEVICE (1)
8 22-12-0200 ENCLOSURE (1)
9 06-82-7299 SCREW (4)
10 31-17-0155 CLAMP (2)
11 44-76-0140 CORD PROTECTOR (1)
12 23-37-0170 CORD SETASSEMBLY (1)
13 22-68-0190 COVER (1)
14 12-98-3080 INSTRUCTION PLATE (1)
15 22-64-5050 CORD SET (1)
16 06-82-7326 SCREW (4)
17 22-56-0480 TERMINAL BLOCK (1)
18 10-98-3030 GROUND LABEL (Not Shown) (1)
19 23-74-2005 1.5MM FERRULE (Not Shown) (3)
20 23-74-2000 1.0MM FERRULE (Not Shown) (2)
SERVICE NOTES:
Screws can use either a flat blade or T-20 screwdriver.•
Cover (13) should mate flush with enclosure (8) before•
securing with cover screws (16). Agap indicates a
misplaced wire or component.
Tighten breaker boot (5) after installing cover (13).•
Cord jackets (12 and 15) are to extend a minimum of .125"•
beyond cord clamps (10), 2 places. Cord set (12) is shown
inside cord protector (11).
Ground label (18) is to be applied to the inside of the•
enclosue (8), under the terminal block (17).
Tuck the red leadwire assembly (3) down below pegs.•