Mini?Cam BEP300 User manual

Brick Egg Stabiliser
BEP300 & BEP150/140
Original Instruction Manual
Version A

2Brick Egg Stabiliser
PLEASE NOTE
BEP300 can only be used with 140mm size wheels
BEP150/140 can only be used with 115mm and 140XL size wheels

3
Brick Egg Stabiliser
BRICK EGG STABILISER
A simple quick fit to our Proteus Crawler, the Brick Egg Stabiliser stops the crawler
from rolling over during inspections in pipes with an egg-shaped profile. Exclusively
compatible with Mini-Cam’s Proteus CRP300, CPL150, CRP150 and CRP140 crawlers
Specifications BEP300 BEP150/140
Product Code BEP300 BEP150/140
Compatible with CRP300 CRP150/140
Length 450mm 375mm
Width 190mm 180mm
Height 220mm 210mm
Weight 2.95kg 2.05kg

4Brick Egg Stabiliser
01
Turn the crawler upside-down and
place on a sturdy raised object while
you carry out the installation of the
Stabiliser. Using T-Bar/Allen key* loosen
the axle bolts of the centre wheel on
each side of the crawler.
*4mm for BEP150/140
6mm for BEP300
02
Remove the centre wheel from each
side of the crawler.
03
Prepare the Stabiliser by removing 4
screws and washers from one half of
the base plate.
04
Separate the two halves of the Stabiliser
ready for installation.

5
Brick Egg Stabiliser
05
The Stabiliser is now ready to attach to
the crawler.
06
Offer the two halves of the Stabiliser
onto the crawler, and overlap the base
plate without screws over the other
base plate with screws.
07
Each side of the Stabiliser should sit and
align over the wheel axles.
08
Ensure the Stabiliser is correctly aligned
and sitting flush with the crawler.

6Brick Egg Stabiliser
09
Tighten the screws in the base plate to
secure to the other half of the base
plate. NOTE: Ensure to use the supplied
washers with the screws, when attaching
the base plate.
10
This completes the installation of the
Stabiliser. Remove the crawler from the
raised object and return the crawler to
the upright position.
11
The crawler is now ready to undertake
an inspection with the aid of the
Stabiliser.
12
EXTENDING THE ARMS
To extend the wheel arms, partially
unscrew the 3 screws to release the
adjustable arm. Position the arm to the
required height. Tighten the 3 screws
to secure the arm into position.
If necessary repeat the process on the
opposite arm.

7
Brick Egg Stabiliser
13
ANGLING THE ARMS
The stabiliser arms can be adjusted to
3 different angles, to suit the shape of
the pipe being inspected. Each arm can
be adjusted independently.
13a
Locate the adjusting device as shown
above.
13b
Use a 4mm T-Bar/Allen key to loosen
and remove the screw. Position the
spring loaded arm to the required
angle. Replace screw into appropriate
hole. Tighten screw to secure arm in
position. If necessary, repeat on the
opposite arm.
Position 1 Position 2 Position 3

©2018 Mini-Cam Ltd. All rights reserved. Mini-Cam and Proteus names/logos are trademarks of Mini-Cam Ltd.
WinCan is a trademark of CD Lab AG. Specifications subject to change without notice. Mini-Cam Ltd is a Halma Company.
Mini-Cam Limited
Unit 4, Yew Tree Way
Stonecross Park
Golborne
Warrington
WA3 3JD
United Kingdom
Tel: [phone]
Email: [e-mail]
www.minicam.co.uk