Mitsubishi Galant Instruction manual

00
11
12
13
14
15
16
17
21
22
23
26
27
31
32
33
34
35
36
37
42
51
52
54
55
00109000812
General ........................
Engine .........................
Engine Lubrication .............
Fuel ...........................
Engine Cooling .................
Intake and Exhaust ............
Engine Electrical ...............
Engine and Emission Control ....
Clutch .........................
Manual Transmission ...........
Automatic Transmission ........
Front Axle ......................
Rear Axle ......................
Wheel and Tyre .................
Power Plant Mount ..............
Front Suspension ...............
Rear Suspension ...............
Service Brakes .................
Parking Brakes .................
Steering ........................
Body ...........................
Exterior ........................
Chassis Electrical ..............
WORKSHOP MANUAL
FOREWORD
This Workshop Manual contains procedures for
service mechanics, including removal, disassembly,
inspection, adjustment, reassembly and
installation. Use the following manuals in
combination with this manual as required.
TECHNICAL INFORMATION MANUAL
PYDE9604
WORKSHOP MANUAL
ENGINE GROUP PWEEjjjj
(Looseleaf edition)
ELECTRICAL WIRING PHDE9608
BODY REPAIR MANUAL PBDE9609
PARTS CATALOGUE
Sedan B608S107Aj
Wagon B608T507Aj
All information, illustrations and product
descriptions contained in this manual are current
as at the time of publication. We, however, reserve
the right to make changes at any time without prior
notice or obligation.
EMitsubishi Motors Corporation Dec. 1996
Interior and Supplemental
Restraint System (SRS) ........
.
Heater, Air Conditioner and
Ventilation .....................
.

WARNING!
(1) Improper service or maintenance of any component of the SRS and seat belt with pre-tensioner,
or any SRS-related component, can lead to personal injury or death to service personnel (from
inadvertent firing of the air bag and seat belt with pre-tensioner) or to the driver and passenger
(from rendering the SRS inoperative).
(2) SRS components and seat belt with pre-tensioner should not be subjected to heat, so remove
the SRS-ECU, air bag module (driver’s side and front passenger’s side), clock spring, side
impact sensor, front seat assembly (side air bag module) and seat belt with pre-tensioner before
drying or baking the vehicle after painting.
SRS-ECU, air bag module, clock spring and side impact sensor: 93_C or more
Seat belt with pre-tensioner: 90_C or more
(3) Service or maintenance of any SRS component and seat belt with pre-tensioner or SRS-related
component must be performed only at an authorized MITSUBISHI dealer.
(4) MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP
52B - Supplemental Restraint System (SRS), before beginning any service or maintenance
of any component of the SRS and seat belt with pre-tensioner or any SRS-related component.
NOTE
Section titles with asterisks (*) in the table of contents in each group indicate operations requiring warnings.