MM Industries ArrowStar XP Series User manual

ArrowStar XP
AS-48-XP
Product Information:
The ArrowStar XP is a stand-alone, steady burn LED light bar that is wired for negative switched
arrowstick traffic director controllers. Each module in the bar will come with its own -12vdc ground wire
and common +12vdc positive. Each ArrowStar XP comes standard with a Sho-Me 11.1025 series rotary
switch traffic director controller.
Wiring Instructions:
The ArrowStar XP comes standard with approx. eighteen feet of hook-up cable. In this cable there will be
multiple wires. Total number of wires depends on length of bar. Connect the following wires to the Sho-
Me controller color for color. (DO NOT REVERSE POLARITY. DAMAGE MAY OCCUR):
Section
1 White
2. Black
3. Brown
4. Green
5. Violet
6. Orange
7. Yellow
8. Blue
X. Red Red wire on Sho-Me or +12vdc
X. Grey Red wire on Sho-Me or +12vdc
Technical Information:
Optimal operating voltage: 12 –14 VDC
Operating current: .47 amps per four inch module
Installation Instructions:
To install the included swivel brackets, remove the end cap screws (two on each end). Place the bracket
over the end cap and re-install both screws. Do not fully tighten screws until you have the proper swivel
position for your installation. To use the suction cups (interior only), install the screw stud into the suction
cup and then install into the swivel bracket using brass nut.

Limited Warranty
MicroMan Industries warrants each new product to be free from defects in material
and workmanship for a time period of 2 years from the date of purchase. During this
warranty period, the obligation of MicroMan Industries LLC is limited to repairing or
replacing, as MicroMan Industries LLC may elect, any part or parts, which after
examination by MicroMan Industries LLC are determined to be defective, when they
are delivered pre-paid. This limited warranty does not cover travel expense, the cost of
specialized equipment for gaining access to the product, or labor charges for the
removal and re-installation of the product.
MicroMan Industries LLC shall not be liable for incidental or consequential damages,
including but not limited to: Loss of Vehicle, Rental of Substitute Vehicle, Loss of
Time, Loss of Work, Inconvenience, Transportation Expenses, Telephone, Lodging,
Loss of Revenue, Loss of and/or Damage to Personal Life or Property for or arising
out of improper use, failure of this product and/or breach of any expressed or implied
warranty of its products. These products are produced and sold as a general purpose
light source with no one specific area of emphasis.
Use of lamp or other electrical load of awattage higher than installed or recommended
by the factory, or use of inappropriate or inadequate wiring or circuit protection, or
usage of voltage higher than specified for that product causes this limited warranty to
become void. MicroMan Industries LLC will in no way be liable for any loss of profits or
any indirect or consequential damages arising out of any such defect in material and
workmanship whether loss is due to negligence or breach of warranty. This limited
warranty does not apply to shipping damage, accident, alteration, tampering, misuse
or abuse and unauthorized service.
This limited warranty is expressly in lieu of all other express or implied warranties,
including the implied warranty of merchantability and the implied warranty of fitness for
a particular purpose, and of all other obligations or liabilities on the part of Microman
Industries LLC. There are no warranties, unless expressed in writing by Microman
Industries LLC, which extend beyond the description of the face hereof. No dealer,
distributor, employee, or representative of the company is authorized to change this
warranty in any way or to grant any other warranty.
MICROMAN INDUSTRIES LLC 912 N. SEMINOLE CT. INDEP. MO 64056
[phone] Mon.-Fri 9am-5pm CDT
Web: www.micromanindustries.com Email: [e-mail]