INTRODUCTION
At MMATS Pro Audio we are constantly striving to manufacture the
best possible products for Car Audio. With the introduction of our all
new HiFi 6150D, Sound Quality has just been pushed to a new level.
We have put The Best of what we know into this amplifier. This is
our finest offering we have made since our pioneering of class D
back in 1995 to the Car Audio industry. With a Burr-Brown front end
and a slew rate of 19v/m second, you will immediately hear the
difference in this amplifier.
Congratulations on your purchase and if you have any comments, we
would love to hear from you. dthompson@mmatsproaudio.com
FEATURES :
Ultra-High Efficiency Full Range Class D.
82% Efficient @ full power 6 channels driven @ 4 ohms.
At full power all channels driven into 4 ohms the
amplifier will never go into thermal shutdown!!
Burr-Brown Pre-amp section
Adjustable 24db LP / HP Filter.
1% Surface Mount Components.
Computer Optimized Transformer.
3 ounce copper overlay PCB.
Overload and Thermal Protection
3-year manufacturer’s warranty when installed by an
authorized dealer, 1 year otherwise. No warranties on
any MMATS products purchased through the internet.
CONTROLS AND CONNECTORS
(1) Positive Power Terminal –This is the power feed from the
positive (+) terminal of the car’s battery. Use 4-gauge cable
(MINIMUM) and good quality terminals when routing this connection.
Tighten all connections well to prevent power loss due to bad
contact. Route the power cable away from the RCA jacks and
speaker cables
1) Ground Terminal - For optimum performance, use a 4-gauge
cable MININUM! Connect this cable to your battery’s negative (-)
terminal.
Recommended Fuse –80 amps.
Remote Terminal - The amplifier will turn on when 12 volts is
applied to this terminal. This 12-volt signal is usually taken from the
Power Antenna or Remote wire coming from the source unit.
Speaker Terminals - Connect to speakers using 16-gauge wire
(minimum). Running too low of a speaker impedance will cause the
amplifier to go into a fault condition.
Crossover Filter –Linkwitz/Riley 24db slope. This control sets the
6db down point of your amplifier.
Gain –Allows input levels between 150mV (max gain) and 5 volts
(min gain) for full output.
