MN Mounting Solutions WRM-250 HV User manual

Installation Guide
WRM - series
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
Installation Guide for WRM-series Wall
Mounting Systems
Models:
SAFETY INSTRUCTIONS
1. Only entrust loudspeaker mounting equipment to experienced professionals. Also strictly follow the provided safety instructions.
Improperly installed mounting equipment may result in property damage, personal injury and/or liability for the installing
contractor.
2. Always use safety cables! This will prevent equipment from falling during/after setup and while exploiting.
3. Always check if the wall surface is structurally strong enough to support load. Make sure the wall and/or ceiling structure allows
to hold the weight of the speaker including its bracket.
4. Only use appropriate fasteners.
5. Always make sure to securely use and tighten/lock all mounting bolts provided. Loose bolts may become unscrewed over time
due to vibration which could potentially create a safety hazard when not tightened securely.
WRM-250 WRM-250 HV
WRM-300 WRM-320

Installation Guide
WRM - series
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
1. First, release the upper bolt which
securing the speaker plate to the
bracket arm. Now remove the speaker
plate from the arm.
2. Screw the speaker plate to the rear
(4) holes of the loudspeaker by using all
(4) bolts.
Installation Instructions:
1
2
3
3. Install the wall plate incl. bracket
arm to the wall surface by using a level
and at least (4) fasteners.
3.1. To install the bracket on the
opposite wall, simply turn the wall plate
180 degrees. Unbolt the upper bolt,
make sure the lower bolt is bolted in
and proceed from step 2.
3.1

Installation Guide
WRM - series
www.mnmounting.com
[email protected]om
2 Merezhna str., Bila Tserkva,
Kyiv region, 09100, Ukraine
4. Slide the speaker plate along with
the loudspeaker onto the lower bolt of
the tilt mechanism.
5
4
5. Press down on the top of the
loudspeaker until it stops and then
tighten the upper bolt of the speaker
plate.
6
6. Adjust the pan and tilt angles of the
loudspeaker as required and tighten
the (4) xing bolts to lock in the position
of the loudspeaker.