
2. SETTING THE CURRENT DATE
Pull the winding crown of the movement out into position III.
Turn the winding crown counterclockwise to set the current date.
3. SET THE CURRENT TIME
Pull the winding crown of the watch movement out to position IV.
Turn the winding crown counterclockwise to set the current time.
Push the winding crown back into its original position. The second
hand will start moving.
After setting the current date, the time and having wound the watch,
return the winding crown to the neutral position by pressing it in
towards the case and return it to the safe/screwed-down position by
rotating it clockwise. The watch is only guaranteed water resistance
at a depth of 100 m when the winding crown is in this position.
INSTRUCTIONS FOR USE, CARE AND STORAGE
1. WATER RESISTANCE
Chameleon watches have a water resistance of 10 atm, this
water resistant mark is conditional and denotes a pressure of 10
atmospheres. This watch will not be damaged by splashes or rain,
and you can wash your hands without taking it off. You can swim with
this watch and it can be submerged in water. However, these watches
are not suitable for scuba diving.
Over time, seals will age and become worn, which will have a negative
impact on the water resistance of the watch. We recommend that you
have the condition of the gasket examined and the water resistance
checked once a year at an authorized service center and have the
seal replaced if necessary.
ATTENTION: IF YOU CONTINUE TO WIND THE WATCH AFTER YOU HAVE
FELT RESISTANCE, YOU RUN THE RISK OF BREAKING THE TIP OF THE
SPRING. IF THIS OCCURS, THE BARREL WHERE THE MAINSPRING IS
WILL NEED TO BE REPLACED AT THE OWNER’S OWN EXPENSE.
Do not set the date between 21.00 and 01.00. This could damage
the watch movement. ATTENTION: PLEASE REMEMBER THAT YOU MUST NOT PULL THE
CROWN OUT WHEN THE WATCH IS WET.