Molnija ENERGY User manual

ENERGY
PASSPORT

Note:* To accurately set the time to the nearest second, pull the
winding crown out when the second hand is at twelve o’clock (|). After
setting the hour and minute hands , push the winding crown back in
to position I at the same second.
Pull the winding crown out to position III (the watch will stop).
Turn the winding crown until the correct time is set 08:45.
Push the winding crown back in to position I.
1 – Hour hand
2 – Minute hand
3 – Second hand
4 – Central second hand
5 – Day of the week
6 – Minute counter
7 – Date
8 – Pusher A
9 – Pusher B
10 – Winding crown
DESCRIPTION, FUNCTIONS AND DISPLAYS
60
60
60
15
15
15
30
30
30
45
45
45
30
30
30
05
05
05
15
15
15
25
25
25
10
10
10
20
20
20
1
1
1
1 2 3
2
3
3
3
2
4
69
8
10
5
*
*
II I II II II
секундная стрелка
III
SETTING THE TIME
7

SETTING THE DATE (QUICK SET-UP)
Pull the winding crown out to position II (the watch will continue to
run).
Turn the winding crown until the correct date is set 0 1 .
Push the winding crown back in to position I.Pull the winding crown out to position III (the watch will stop).
Rotate the winding crown clockwise until you reach yesterday’s date.
Push the winding crown back in to position II.
Turn the crown until you see yesterday’s date 2 2
Pull the winding crown out to position III (the watch will stop).
Turn the winding crown counterclockwise until the correct date 2 3
is visible as well as the correct day of the week THU.
Continue to turn the winding crown until the time is correct 20:35.
Push the winding crown back in to position I.
1
1
2
2
3
3
4
5
6
7
8
60 60
15 15
30 30
45 45
30 30
05 05
15 15
25 25
10 1020 20
1
1 2 3
II III II
дата
Note. You can change the date between 21:00 and 12:00. Please remember
that you can only set the date forward, ahead of the current date.
Example: Date/time on the watch: 17/01:25/MON
Current date and time: 23/20:35/THU
*
*
*
**
1 1
0
SETTING THE DATE, DAY OF WEEK AND TIME

60
60
60
60
60
60
15
15
15
15
15
15
30
30
30
30
30
30
45
45
45
45
45
45
30
30
30
30
30
30
05
05
05
05
05
05
15
15
15
15
15
15
25
25
25
25
25
25
10
10
10
10
10
10
20
20
20
20
20
20
1
2
52
1
4
7
6
3
83
II
II
I
I
II
II
III
III
III
III
II
II
Date
Winding
crown
1 0 1
Second hand
Minute counter
Pusher A
Pusher B
Note.* To accurately set the time to the nearest second, read the
instructions under the heading «Setting the time».
** Please make sure the time of day is suitable for setting the time.
CHRONOGRAPH: THE BASIC FUNCTIONS (START / STOP / RESET)
Example:
Start: Press pusher A
Stop: To stop the counter, press pusher Ain again and read the two
chronograph counters: 20 min /10 sec
Reset the counter:
Press pusher B.
(2 chronograph hands return to zero).
1
2
3
Example: Date/time on the watch:
Current date and time: 17 / 01:25 / MON 23 / 20:35 / THU

60
60
60
60
15
15
15
15
30
30
30
30
45
45
45
45
30
30
30
30
05
05
05
05
15
15
15
15
25
25
25
25
10
10
10
10
20
20
20
20
11
3
3
2
2
4
4
55
Minute counter
Minute counter
Pusher A
Pusher A
Pusher В
Pusher В
Pusher В
RESUMING THE COUNTER
Example:
Start: starting time.
Stop: e.g.: 15 minutes 5 seconds after
Restart: The count resumes
Stop: e.g. 13 min 5 sec after = 28 min 10 sec
(The sum of the recorded time is displayed)
Reset: 2 chronograph hands return to zero.
CHRONOGRAPH: THE INTERMEDIATE REFERENCE TIME AND INTERVAL
COUNT
Example:
Start: starting time
Interval display: e.g. 10 min 10 sec (Counting continues in the
background).
Catching up with the recorded time: The 2 chronograph hands will
quickly take position according to the recorded time.
Stop: The final time is displayed.
Reset: 2 chronograph hands return to zero.
11
1
22
3
3
4
4
4
5
5
3
*
*
Please note: * The step can be repeated to add to the recorded time
spans, the counter can be resumed by pressing pusher A. (Restart / Stop,
Restart / Stop,...)

II II III
Note: * After this step, counter readings for recorded time spans
or intermediate readings can be viewed by pressing pusher B. (Interval
display, catch-up to the recorded time...)
3
RETURNING THE CHRONOGRAPH HANDS TO ZERO
Example: One or more chronograph hands are not at zero (for example,
after replacing the battery) and need to be set to that position.
Pull the crown out to position III. (The 2 chronograph hands are in
their correct zero position or incorrect position).
Press and hold down pushers A and B at the same time for at least
2 seconds (the centre second hand will rotate 360 ° —, and the
adjustment mode will be activated).
Bringing up the central second hand
In one step: A 1 x short movement
Continuously: A long movement
Bringing up the next arrow In
Bringing up the hand for the minute
counter (6 o’clock position)
In one step: A 1 x short movement
Continuously: A long movement
Return the winding crown to position I.
Finish setting the chronograph arrows
(can be done at any time).
1
2
60 60
15 15
30 30
45 45
30 30
05 05
15 15
25 25
10 1020 20
1
33
2
II II III III
Minute counter
Central second hand Pusher A
Pusher В
В
А
А

INSTRUCTIONS FOR USE, CARE AND STORAGE
1. WATER RESISTANCE
Energy watches have a water resistance of 10 atm, this water resistant
mark is conditional and denotes a pressure of 10 atmospheres. This
watch will not be damaged by splashes or rain, and you can wash
your hands without taking it off. You can swim with this watch and it
can be submerged in water. However, these watches are not suitable
for scuba diving.
2. CARE
We recommend that you clean the watch regularly (except for the
leather strap) with a soft cloth moistened with warm soapy water.
Over time, seals will age and become worn, which will have a negative
impact on the water resistance of the watch. We recommend that you
have the condition of the gasket examined and the water resistance
checked once a year at an authorized service center and have the
seal replaced if necessary.
ATTENTION: PLEASE REMEMBER THAT YOU MUST NOT PULL THE
CROWN OUT WHEN THE WATCH IS WET.
Never attempt to open the case or remove the back cover by yourself.
The rubber gasket protecting the watch from water and dust should
be replaced every 2-3 years.
If the inside of the watch gets wet, you should bring it to an authorized
service center to have it checked immediately.
Do not expose the watch to extreme temperatures.
Treat the watch with care and avoid any hard impact (bumps, falls, etc.).
Do not fasten the strap too tight. You should be able to slide a finger
between your wrist and the strap.
The watch should be stored in a dry place.
Do not let it come in contact with gasoline, cleaning solvents, spray
aerosols, adhesives, paint, etc. These substances cause chemical
reactions which could damage the gasket, case and the polished
surfaces of the watch.
Sapphire crystal is quite durable, but it may crack if the watch is
dropped or hit.
Avoid storing your watch with precious jewelry, as diamonds can
damage sapphire crystal.
3. PRECAUTIONARY MEASURES

It is preferable to store the watch in a special separate box, lined with
soft protective material.
TECHNICAL SPECIFICATIONS
Case diameter
Case material
Strap width
Type of glass
Movement
Accuracy
Standard battery
Battery lifetime
46 mm
316L Steel
22 mm
Sapphire crystal
Ronda Z60 quartz movement
-10 ...+20 seconds per month
395
50 months
In accordance with the Decree of the Government of the Russian
Federation No. 471 from 27.05.2016 «On amendments to certain acts of
the Government of the Russian Federation on the return or exchange
of technically sophisticated goods», this product is categorised as
a technically sophisticated, and therefore, the buyer does not have
the right to demand a free replacement for the repair period or a
demand it be replaced with a similar product, and the buyer does
not have the right to return or exchange the product with similar
products of a different size, shape, different dimensions, style, colour
or configuration.
The warranty only applies to products purchased from authorized
sales outlets.
The manufacturer’s warranty is valid for one (1) year from the date
of sale of the product. The warranty covers defects and faults in
assembly materials. If a problem should arise during the warranty
period, the manufacturer shall rectify any defects or repair any
malfunctions absolutely free of charge. If the quality of the watch is
not able to be restored through repairs, the manufacturer guarantees
the replacement of the watch with the same watch or a model
WARRANTY

with identical specifications. Repairs should only be carried out at
authorized service centres. The contact details for authorized service
centers are provided by authorized sales representatives.
LIMITATIONS AND RESTRICTIONS
The warranty does not cover:
glass and strap;
wear and tear or defects resulting from the use of the watch (e.g.
scratches on the glass, changes in the colour and/or material of non-
metallic straps and bracelets, etc.));
any damage to any part of the watch resulting from improper use,
lack of care, or careless handling of the watch (bumps, chips, dents,
cracks, etc.).);
any unauthorized repair or the owner’s own tampering with the
design of the watch and/or its appearance automatically excludes
these watches from warranty service.
name of trading
organization
Address and phone
number
(trading organization)
All warranty claims for repairs must be accompanied by a warranty card
which has been filled out by both the buyer and the vendor who sold
the watch.
STAMP HERE
ATTENTION! THE WARRANTY CARD IS NOT VALID
WITHOUT THE VENDOR’S STAMP!
BUYER
I have read and agree with the terms of use. I do not
have any complaints regarding the appearance or the
performance of the watch.
WARRANTY CARD
VENDOR
SERIAL NUMBER
DATE OF SALE

Name of the authorized service centre
(Signature, full name)
(Signature, full name)
The following steps have been taken in troubleshooting:
Service centre employee
Owner
Date
Date
NOTES