Molpir TGS-16T User manual

NU
_
TGS
_
00
0
_
29042016_EN
Date: 29.03.2016 Page 1 / 4
1
1. . Diagram and Instructions
1 - Antenna (for TGS-16T on y)
2 - LCD disp ay
3 - Down button for channe and ao ume adjustment
4 - On / Off / Mutte / Set Button
5 - Up button for channe and vo ume adjustment
6 - Microphone input for Transmitter Earphone output for Receiver
7 - Lanyard connection point
8 - Labe area
9 - Battery compartment and bui t-in Li-Po battery
10 - Lid of battery compartment
11 - Micro-USB charging port
O
rder code
:
TGS
Front view
Front view
Side
view
Side
view
Rear
view
Top
view
TGS
-
16T
Top
view
TGS
-
16R
Bootom view
LCD display
Channe
Lock key
Channe
Battery
eve
Vo ume
Mut
e

NU
_
TGS
_
00
0
_
29042016_EN
Date: 29.03.2016 Page 2 / 4
2
2. . LCD Display Illustration
3
3. . Operating Instructions
3.1. Microphone and Earphone Connection
Connect the microphone/headset to the 3.5mm socket on the transmitter and the
earphones to the 3.5mm socket on the receiver. Make sure the connectors are
proper y insered in p ace
3.2. Power On and Off
Press and ho d the power button / for 2 seconds to turn on the system. The
LCD disp ay wi i uminate and receive the channe number used ast time 10 indicate
Power on successfu y
Press and ho d the power button / for 2 seconds. The LCD disp ay wi
disappear to indicate Power off comp ete y
Energy saving-Receiver wi automatica y power off if no signa is received after
about 20min
3.3. How to se ect a channe
The channe is preset to . If you wish to se ect a different channe , press and
buttons simu taneous y for 2 seconds. The sign starts f ashing and icon is
removed to indicate channel escape from lock mode. Press or button to select your desired
channel. Press button / briefly to confirm the selected channel or wail for approximately 5
seconds to automatically store and lock the selected channel will stop flashing and LCD
displays icon. System now returns to lock mode.
Note:
Make sure that the transmitter and receiver(s) operate on the same channe . The
receiver disp ay wi keep f ashing when no transmission signa is being recived
System wi retrieve channe number used previous y
TGS-16T TGS-16R TGS-16T TGS-16R
Channe Lock - No signa receiver
Channe change 100% battery remaining
Mute/Mic disconnect Mute 70% battery remaining
eve 4 microphone vo ume eve 4 microphone vo ume 30% battery remaining
10% battery remaining

NU_TGS_000_
29042016_EN
Date:
29
.
03
.201
6
Page
3
/
4
Aux in
To transmitter
LM
-
15 Lape microphone
3.4. Transmitter Using LM-15 Lape microphone
The Aux input port on the LM-15 microphone accepts externa ine- eve audio source,
for examp e CD/MP3 p ayer. An idea too for you to p ay audio source whi e making
a speech
Connect LM-15 microphone to the 3.5mm socket on the transmitter
Transmitter vo ume is preset at eve
Press or button to decrease or increase the vo ume eve . There are 4
adjustment eve s from to .
Press mute button brief y to mute the transmitter, press the same button once
again to recover
LM-15 features a microphone-mute switch; Switch to „mute“ when you ike to p ay
the aux input source a one or to have private conversation
3.5. Transmitter Using microphone other than LM-15
The 3.5mm socket on the transmitter accepts mic and ine eve input source
The defau t input is set to microphone eve
Connect microphone to the 3.5mm socket on the transmitter
Transmitter vo ume is preset at eve 4
Press or button to decrease or increase the vo ume eve . There are 4 adjustab e
eve s from to
Press mute button brief y to mute the transmitter. Press the same button once again
to Recover.
3.6. Receiver
Receiver vo ume is preset at eve 4
In norma state be disp ayed, press or button to decrease or increase the
vo ume eve . There are 8 adjustab e eve s from to
The LCD disp ay indicates no vo ume and in mute mode

Note! Specification may be changed without prior notice.
NU
_
TGS
_
00
0
_
29042016_EN
Date: 29.03.2016 Page 4 / 4
3.7. Battery Autonomy and Charging
When battery icon is disp ayed at fu autonomy , the battery contains sufficient
power
When the battery icon is disp ayed as empty and f ashing this indicated ow
battery and on y 10% battery remaining. Recharge the battery immediate y via USB
certified trave ing charger (optiona accesories). 6 hours to reach fu charge and
provide approx. 16 hours of continuous operation for receiver and 11 hours of
continuous operation for transmitter
Whi e charging the battery icon disp ays on LCD back and forth
Note:
The transmitter or receiver wi shut down automatica y when charging is taking
p ace. If you want to use the system whi e it’s charging, simp y press the power
button again to turn the system back on Q&A
Q1 Sign is disp ayed on Transmitter
Ans Check if the transmitter vo ume is muted or the microphone connection is not
proper y attached
Q2 The content on the LCD disp ay of my receiver is f ashing
Ans This indicates that no transmission signa is being received. Make sure your
transmitter is powered on. Both transmitter and receiver are operated on the same
channe and same frequency