MonLines MWH005B User manual

EN
Be sure to read the assembly instructions before assembly - installation - commissioning!
This wil l protect you and prevent damage to your product.
Subject to change without notice
MonLines
Am Marienhof 8
22880 Wedel
Germany
E-Mail: [e-mail]
Web: www.monlines.com
Tel.: [phone] / 90387 - 0
Fax: [phone] / 90387 - 11
1. Scope of delivery
Before the actual installation, please observe the following instructions for proper installation:
1. This bracket is designed to be installed and used only a s specified in this manual. Improper installation of this product
may cause damage or serious injury.
2. This product should only be installed by a person with manual dexterity and basic knowledge and experience in
assembling.
3. Make sure that the surface on which the bracket is to be mounted can safely support the total load of the unit and all
components connected to it.
4. When mounting the bracket on a wooden stud wall, ensure that the bracket screws are fixed in the centre of the studs.
It is strongly recommended that you use a joist finder.
5. For safety reasons, only lift and position equipment in pairs or with a mechanical lifting device.
6. Tighten bolts firmly, but do not overtighten. Overtightening can damage the components and significantly reduce their
holding power.
7. This product is intended for indoor use only. Outdoor use may result in product failure and personal injury.
2. Assembly preparation
Make sure that you have received all the parts includ ed in the delivery before you start the assembly. If any parts are missing
or defective, please contact your dealer.
MonLines MWH005B
Tiltable TV wall mount
Mounting instructions
Wallplate(1x)
A
linkerHaltearm(1x)
B
rightsupportingarm(1x)
B
M5x14(4x)
MA
M6x14(4x)
MB
M6x30(4x)
MC
M8x30(4x)
MD
M8x50(4x)
ME
washer(4x),
MF
smallspacer
holder(8x),
MG
bigspacer
holder(4x),
MH
ST8x50(6x)
WA
concretedowel
(6x),WB
D8washer(6x),
WC
5. Hanging the TV / monitor in the wall plate
Hook the television into the wall plate. Tighten both
screws with a suitable Phillips screwdriver.
Loosen the slider for adjustment, set the desired
inclination and then fix the slider again.
6. Aligning the TV / monitor
Tightenthe
screws
Controller
forthe
inclination
Screw
leftsupportingarm(1x)
B

EN EN
Version no. 2021-11 - Assembly instructions MonLines 2 Assembly instructions MonLines MWH005B - Version no. 2021-
4. Installing the support arms
3a. Mounting on wooden stud walls
Ensure that the screws are fixed centrally in the joists, if
necessary use a joist finder to determine this.
The installer will ensure that if conditions change, the
bracket is equally securely fastened accordingly.
The installer must ensure that the surface on which the
bracket is anchored can safely support the total load of
the unit and all components connected to it.
3b. Mounting on stone and concrete walls
The installer must ensure that the surface on which the
bracket is anchored can safely support the total load of
the unit and all components connected to it.
Note: Select the screws, washers and spacers (if necessary) according to the condition of the TV back. Align the arms as
centrally as possible on the back. Screw the adapters tightly to the TV. Tighten all screws, but do not overtighten.
For TVs / monitors with flat backsides
For TVs / monitors with curved backsides
Drillholes
Tightenthe
screws
Marktheexact
positionofthe
holes
Drillholes
Tightenthe
screws