MORVAT GOLF NET User manual

ITEM # MOR-GNGA-A ITEM # MOR-GNGA-A[email protected] [email protected]©MORVATBRANDS ©MORVATBRANDS
7
Package Contents:
ASSEMBLY INSTRUCTIONS
Insert pole E1 into D1 and pole E2 into D2.
Note: The poles might be a little difficult to insert
but that is to be expected.
Note: To disassemble, follow the steps in the reverse order.
Be sure to test out your swing in order to gauge how far to stand back while hitting. This will avoid being
hit by bouncing balls.
Loop the black loops on the bottom of the net
around the coil on the shorter side of poles A1
and A2.
Step 7
Step 8
(1) 2 ‘A’ Poles (A1 & A2)
(2) 1 ‘B’ Pole
(3) 2 ‘C’ Poles (C1 & C2)
(4) 2 ‘D’ Poles (D1 & D2)
(5) 2 ‘E’ Poles (E1 & E2)
(6) 1 Net
(7) 1 Mat
(8) 3 Golf Balls
(9) 2 Adjustable Tees
(10) 5 Wooden Tees
(11) 4 Stakes
(12) 1 Carry Bag
GOLF NET
6
6
8
9
11
12
10
A2
A2
B
C1
C2
D1
D1
D2
D2
E1
E1
E2
E2
A1
A1
6

ITEM # MOR-GNGA-A ITEM # MOR-GNGA-A[email protected] [email protected]©MORVATBRANDS ©MORVATBRANDS
Unfold poles A1 and A2 to form 2 right angles.
The longer side of each pole should meet up in the center to be connected soon.
Stand pole C1 and C2 upright and insert pole C1
into the corner of A1 and pole C2 into the corner
of A2.
Lay and insert pole B in between the longer side of poles A1 and A2.
Note: Pole B is supposed to be bent. The bend should face upwards so there is a small gap between
pole B and the floor.
Fasten the Velcro sleeves of the net around
pole D on both sides.
Make sure the white loops of the net are on the
top and the black loops are on the bottom.
Attach the white loops of the net to the tops of
poles E1 and E2.
Stand poles D1 and D2 upright so that the silver
side is facing upwards. Insert pole D1 into C1 and
pole D2 into pole C2.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
6
6
6
6
6
6
A1
A1
A1
A2
A2
A2
A2
A2
B
B
B
C1
C1
C2
C2
D1
D1
D2
D2
A1
A1
E1
E1
E2
E2