Moso Pop Pillar Brochure Holder User manual

For more information please visit: nice.moso.design
ASSEMBLY GUIDE
Pop Pillar Brochure Holder (18” X18” X 80”)
ASSEMBLY GUIDE
POP PILLAR BROCHURE HOLDER ASSEMBLY INSTRUCTIONS pg 1
Step 1 Remove cardboard sign from the packaging.
Unfold the tower and lay flat on a table or clean surface.
Step 2 Fold bottom stabilizing foot up and insert tabs
into the the corresponding notches.
Step 3 Flip over your sign, Tape the Tabs down to give
the tower more stability. (optional)
Step 4 Fold the Sides up towards the middle. Remove
the tape from the flap.
STEP 1
STEP 2
STEP 4
STEP 3
Step 5 Align the edge at the bottom of the tower as
straight and square as possible. Tack to the top edge.
STEP 5
Step 6 Using your hand, press the back of the cardboard
firmly against the flap smoothing it out from the middle.
STEP 6

ASSEMBLY GUIDE
Pop Pillar Brochure Holder (18” X18” X 80”)
ASSEMBLY GUIDE
POP PILLAR BROCHURE HOLDER ASSEMBLY INSTRUCTIONS page 2
Step 7 Remove the backing material from the brochure
holder. Fold the brochure holder flaps back to create a
straight folded edge.
Step 8 Poke holes for
brochure holders. Insert the
side tabs of the brochure
holder into the vertical slits
in the tower. Then push the
bottom tab in the
horizontal slit.
Repeat steps 7and 8until
all holders are placed on
the tower.
STEP 8
STEP 7
For more information please visit: nice.moso.design
Step 9 Place brochures in to the holders.
STEP 9