Mount-It! MI-4200 User manual

Under-cabinet/Ceiling Mount
INSTALLATION MANUAL
CAUTION:DO NOT EXCEED
RATED LISTED WEIGHT.SERIOUS
INJURY OR PROPERTY DAMAGE
MAY OCCUR!
MI-4200 23"
MAX 8 kg
(17. 6l bs )
R ATED
50x50
75x75
100x100

WARNING
NOTE: Read the entire instruction manual before you start installation and assembly.
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
This mounting bracket was designed to be installed and utilised ONLY as specified
in this manual. Improper installation of this product may cause damage or serious
injury.
This product should only be installed by someone with good mechanical ability who
has basic building experience and fully understands this manual.
Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
Tighten screws firmly, but do not over tighten. Over tightening can cause damage to
the items, This greatly reduces their holding power.
This product is intended for indoor use only. Using this product outdoors could lead
to product failure and personal injury.
•
•
•
•
•
•
1

Component Checklist
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to
installation. If any parts are missing or faulty, telephone your local distributor for a
replacement.
(1) ceiling mount
(4)M4x14-A (4)M5x14-A (4)M5 washer-A
Package
(6)ST5.5x50-B (6)concrete anchor-B (1)Wrench-C
2

50m m(2 ")
4mm
( 5/3 2")
3a.For Wooden Ceiling Mounting
1.Find and mark the
exact location of
mounting holes.
3.Screw the screws
into the ceiling
2.Drill pilot holes
3MM
Tighten the screws
leaving a 3mm
space to ceiling
Wooden ceiling
B
3

WARNING
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
Align the both holes of ceiling plate to
the screws in ceiling and move the
ceiling plate until the both screws are
seated in small area of tear-drop
mounting holes.
Fix the ceiling plate using four screws and then tighten all screws.
B
4

3b.For Solid Brick and Concrete Mounting
3MM
Tighten the screws
leaving a 3mm
space to ceiling
1.Find and mark the
exact location of
mounting holes.
3.Screw the screws
into the ceiling
2.Drill pilot holes
8mm
( 5/1 6")
55mm(2.2")
Solid Bric k
B
B
5

Align the both holes of ceiling plate to
the screws in ceiling and move the
ceiling plate until the both screws are
seated in small area of tear-drop
mounting holes.
WARNING
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
Fix the ceiling plate using four screws and then tighten all screws.
B
6

4.Attaching the Display to the VESA Plate
5.Adjustment
For saving the space, you can fold the display by pushing the display back until it fits in place.
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.
Rivision Date:2017/8/8
0°---110°
360°
Please tighten the screw if the
ceiling mount can't be stayed
in the desired position during use.
Adjust to the desired position.
C
A
7