Mount-It! MI-772 User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
!Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
!Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
!Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
!Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
!Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied Par ts List
2
(1) 48mm Pole-a (2) Side Vesa Plate
with Slip Set-c
(2)Arm Plastic
Cover-i
(8)M4x30 Bolt-m
(16)M4 Washer-k
(1)Allen Key-j
(2) Short Arm-d
(1) Arm Clamp-f (4)M6x25 Bolt-g (4)M6 Washer-h
(1) Arm Connect
Part-e
(8)M4 Space-n (2)M8x10 Bolt-o (2)Wire Clip-p
(1) Disconnected
“C” Clamp-b
CAUTION!
WARNING
!This monitor desktop mount must be securely
attached to the horizontal desk. If the mount is
not properly installed it may fall, resulting in
possible injury and/or damage.
(2)M10x15 Bolt-q
(8)M4x12
Thumb Bolt-l

Assemble the curved arm sets as the
diagram above, fasten the M6x25
Bolt(g) by provided Allen Key(j).
Insert the curved arm sets to pole,
fasten the M8x10 Bolt(o) by provided
Allen Key(j). Install the Wire Clip(p).
p
o
Step 2 Assemble the Arm Sets and Install it on the Pole
Step 1 Install the “C” Clamp According to the Desktop Thickness
3
a
b
q
j
The depth of “C” clamp can be changed in
three positions. Choose the proper depth
according to the thickness of your
desktop. Connect it by 2pcs M10x15
bolts(q), using the supplied Allen Key(j).
d
ghe
f

4
Step 3 Mount the Monitor to VESA Plate
For Curved Back Monitor
n
k
m
k
Step 4 Attach the Monitors to Arm Sets
i
Plastic Knob
c
Attaching the monitors to the curved arm sets, fixing the position by the plastic
knob. Install the Arm Plastic Cover-i as the above diagram.
For Flat Back Monitor
k
l
For Flat Back Monitor

5
Step 5 Adjust the Tilting Angle and the Monitors Level
Fasten the grub screw to fix the tilting
angle by provided Allen Key(j).
grub screw
Bolt
By fasten or loosen the bolt on the
above diagram to adjust the level of
each monitor.
Step 6 Manage the Wires