Mount-It! MI-7916 User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
!Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
!Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
!Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
!Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
!Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage arising
from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied Par ts List
2
(1)Gas Spring Arm-d (1)L Plate-e (1)Wrist Pad-f
(1) Base-b(1) Monitor Platform-a (1) Keyboard Tray-c
(2)Spacer-k (4)M6 Washer-l (4)M6 Nut-m
(1)Allen Key-p
(2)Square Pad-n
(4)Round Pad-o (1)Wrench-q
(2)M6x35 Bolt-j (4)M6x28 Bolt-i(4)M6x12 Bolt-g (4)M6x12 Bolt-h

Step 1 Connecting L Plate to Keyboard Tray
3
Warning:
Ensure screws are
secured firmly.
!
Step 2 Attaching Square Pads to the Back of Keyboard Tray
c
e
g
p
n

4
Step 4 Connecting L Plate to Gas Spring Arm
Warning:
Ensure screws are
secured firmly.
!Warning:
Don’t operate the lever until the
workstation is fully assembled.
!
Lever
on right
lm
“L” plate can be connected to the Gas Spring
Arm in two different positions.
1. Install in a low position for fitting the
keyboard tray to the surface of desktop
directly.
2. Install in a high position for leaving some
space between the keyboard tray and the
surface of desktop.
d
Step 3 Make Decision for the Lever Location
Lever located on Left or Right?
Lever
on left
Wire go through
this gap

Warning:
Ensure screws are
secured firmly.
!
Step 5 Connecting Gas Spring Arm to Monitor Platform
h
a
5
Step 6 Attaching Lever to the Back of Monitor Platform
Warning:
Ensure screws are
secured firmly.
!
k
j
Note: The lever can be installed
eigher on the right or the left
side of monitor platform.

Warning:
Ensure screws are
secured firmly.
!
Step 7 Connecting Base to Gas Spring Arm
i
p
b
6
Step 8 Attaching Round Pads to the Back of Base
o

Step 9 Attaching Wrist Pad to Keyboard Tray
f
7
Step 10 Operating the Lever to Lift or Lower the WorkStation

Step 11 Adjusting the Tension of Workstation
• If the weight of the monitor(s) makes it difficult to lift the workstation, adjust the screw
at the back of the gas spring arm counterclockwise.
• If the workstation lowers too quickly, adjust the screw at the back of gas spring arm
counterclockwise.
• If the workstation doesn’t easily lower down, adjust the screw at the back of gas
spring arm clockwise.
8