Mount-It! MI-7157 User manual

Multifunctional Thin Client
CPU Holder
Installation Manual
SKU: MI-7157
Monday - Friday from 8:00am - 4:00pm PST
[email protected] www.mount-it.com(855) 925-5668
HAVE QUESTIONS?

Supplied Parts & Hardware
Required Tools
Thank you for choosing Mount-It!!
23
lbs capacity
11
(x1)
Mount
(x1)
Strap
(x1)
Pole Mount Bracket
(x3)
Adhesive Pad
Phillips
Screwdriver
(x2)
M5x25
(x8)
M4x12
(x4)
Washer
I(x4)
Nut
(x4)
ST4.8x16 Screw

Step 1 Step 2A
45
Loosen the knobs and split the Mount into two pieces.
POLE MOUNTING OPTION: Connect the Pole Mount Bracket to the back side of the
pole and attach the Mount with the base to the front of the pole using M5x25 screws.
Attach the Adhesive Pads as shown on the image below. Attach the smaller Mount
piece using the knobs. Adjust the depth of the Mount to suit the depth of your device.
Tighten the knobs to secure the device. Attach the Strap for additional security.

Step 2BStep 2B (Continued)
67
WALL OR UNDER DESK MOUNTING OPTION: Attach Adhesive Pads to inside face of
both Mount ends. Use the outer holes on the Mount with the base to mark drilling locations
on the wall or under desk. Drill holes no deeper than 5/8” (16mm) using a 3/16” (2.4mm)
bit. Run the Strap between the mounting surface and the groove under the Mount. Use 4 x
ST4.8x16 Screws to attach the Mount with the base to the surface. Attach the smaller
Mount piece using the knobs. Adjust the depth of the Mount to suit the depth of your device.
Tighten the knobs to secure the device. Attach the Strap for additional security.

Step 2C Step 2C (Continued)
89
VESA MOUNTING OPTION: Attach the smaller Mount piece to the VESA mount
(75x75 mm or 100x100 mm patterns) using the 4 x M4x12 screws, washers and
nuts. Attach the Adhesive Pads as shown on the image below. Attach the Mount
with the base using the knobs. Adjust the depth of the Mount to suit the depth of
your device. Tighten the knobs to secure the device.
If attaching a monitor to the Thin Client CPU Holder, do not connect the Mount
pieces to each other. Use the 4 holes located on the outer face of the Mount with
the base to attach 4 x M4x12 screws to the monitor. Attach Mount with the base
+ monitor assembly to the smaller Mount piece that is already attached to the
monitor mount(refer to prior installation step). Strap as necessary.

Our US based customer service team is
standing by to answer any questions you
have about your Mount-It! product.
Available by phone Monday - Friday from
8:00am to 4:00pm PST.
Chat live with an agent on our website!
Visit us at www.mount-it.com for product registration and warranty information.
www.mount-it.com
[phone]
[email protected]