Lantern Features:
USB Output:Easily charge your electronics on the go by
plugging your USB cord into the USB port.
30+ Hours of Continuous Light: Mr. Beams rst LED light
with an ON/OFF feature.
Auto Shut-o: Mr. Beams Lantern turns o automatically
after 60 minutes, conserving battery life (Lantern will blink
after 58 minutes to alert user). To keep on, press the on/o
button.
Bright LED: 260 Lumens covers up to 900 sq ft.
Night Light Mode:Allows user to customize brightness as
needed. Two brightness settings: Full Brightness and Night
Light Mode.
Durable, Weatherproof: Mr. Beams Lantern is equipped with
a weather proof seal.
Tips: Use only new alkaline D-Cell batteries with 1.5V rating. Do not mix old and new
batteries. If batteries are not new, it may cause the light to malfunction. Install batteries
with polarity in correct position. If your low battery indicator is ashing, it
means that it is time to replace the batteries.
Installation Instructions
UltraBright LED Lantern
MB470/480
• 4 D-Cell Alkaline Batteries
• UltraBright LED Lantern
LED Light
Low Battery
Indicator
Rubber Grips
Base
On/O Button
USB Output Port
Durable Weather
Proof Design
Handle
What you need to install:
Thank you for purchasing the Mr Beams®
UltraBright LED Lantern. We are committed to
eliminating darkness using the latest in
Light-Emitting Diodes (LEDs). LEDs are the most
ecient and durable light sources available. We
are certain that your light will contribute to a safer
environment and provide light where you need it at
a very reasonable cost.
What is included:
1. Remove base of the Lantern by rotating clockwise.
2. Release battery door, by squeezing the tab inward and
pulling away from the unit.
5. To charge a device, open USB Port Cover. Plug your device’s USB
cord into USB Port.
3. Insert 4 D-Cell batteries into Lantern with at side towards
spring. Press lid closed and twist base tightly to close.
4. Press the button once to activate light for full brightness. Press
the button a second time for a night light mode. Press the
button a third time to shut o.
7. Remove top of the Lantern by rotating lid clockwise and pulling apart.
8. Turn Lantern upside down and lift hook from the base. Hang the lantern from
your desired location.
Set Up
Charging Electronics on the Go with USB Mode Hanging Mode
Battery Caution:
1) Do not mix old and new batteries
2) Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium)
or (Nickel Metal Hydride) batteries
3) Do not dispose of batteries in re
4)Batteries should be recycled or disposed of as per state and local guidelines
