Nauticam 36052 User manual

Please follow the instructions below to mount the Extension Ring on a port.
1.
Confirm that the e
xtension ring is unlocked,
with the locking device pointing upwards as
shown.
2.
lign the "I" mark on the extension ring
with
the WHITE dot on the port. Then gently push
the extension ring towards the port until it
cannot go in any further
3.
Turn the extension ring clockwise until the
white dot on the extension ring aligns with
the white dot on the port.
1

Please refer to the housin
g manual fo
r procedures to mount the port
o
n
the housing.
4. Push the locking device inwards.
5.
Turn the locking device sideways into the
recess. Ensure that the locking device is
secured inside the recess and the extension
ring is securely locked with the port.
6. To unlock, insert a small screwdriver into the
recess to lift the locking device, then reverse
the above procedures.
1.
M
ake sure the control k
nob is at its mo
st
outwards position before mounting/ un-
mounting the port. The knob should be left at
this position until it is made sure that the lens
and focus gear are properly installed.
2.
Engage the gear by pushing
the
knob
inwards, then turn the knob both ways to
check if the lens focuses.
2