Nauticam 37306 User manual

Current as of 2021-08-05
37306
3730637306
37306
N100 to N120 25mm Port Adaptor
N100 to N120 25mm Port AdaptorN100 to N120 25mm Port Adaptor
N100 to N120 25mm Port Adaptor
Instruction Manual
F
FF
F
OREWORD
OREWORDOREWORD
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recogni e the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allowing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product, this will
maximi e its performance as well as its lifetime.
W
WW
W
ARRANTY
ARRANTYARRANTY
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased from
authori ed NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service, please contact your regional
authori ed service center(s). Please note that this warranty only applies
when the product is purchased in the territory where the service center is
located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthori ed modifications and/or repairs of our products will
automatically invalidate the warranty.
P
PP
P
RECAUTIONS
RECAUTIONSRECAUTIONS
RECAUTIONS
After installation of the port combo, please make sure the O-ring (s) are
free from debris and uneven surface issues.
A water-tight test without the camera inside the housing is highly
recommended after the changing of port and O-ring(s).
Do not use lubricants from other brands with the silicone rubber O-ring
on this housing, only use the lubricant provided by NAUTICAM.
Discontinue use immediately should you notice any leakage.
Do not open the product in a wet or sandy environment. Protect the
interior from moisture and debris in order to prevent malfunction or
leakage.
Defective products should be shipped to our distributors for service,
unauthori ed disassembling and/or modifications could result in
malfunction or leakage.
P
PP
P
ACKA E CONTENTS
ACKA E CONTENTSACKA E CONTENTS
ACKA E CONTENTS
•N100 to N120 25mm Port adaptor
•Rear cap
•1x Spare O-ring
•Lubricant
•Manual instruction card
I
II
I
DENTIFICATION OF
DENTIFICATION OF DENTIFICATION OF
DENTIFICATION OF
P
PP
P
ARTS
ARTSARTS
ARTS
M
MM
M
OUNTIN
OUNTIN OUNTIN
OUNTIN TO A PORT
TO A PORTTO A PORT
TO A PORT
1. Confirm that the port adaptor is unlocked with the locking pin
pointing upwards as shown.
2. Align the “I” mark on the extension ring with the white dot on the
port.
Gently push the port adaptor towards the port until it cannot go
any further.
Port Cap
P
ort Alignment
Index
Port Alignment ‘I’ Mark
Locking Pin

Current as of 2021-08-05
3. Turn the port adaptor clockwise until the white dot on the port
adaptor aligns with the white dot on the port.
4. To lock the port adaptor, push the locking pin inwards.
Ensure that the locking device is secured inside the recess and the
port adaptor is securely locked with the port.
To unlock, insert a small screwdriver into the recess to lift the
locking device, then reverse the above procedures.
S
SS
S
PECIFICATIONS
PECIFICATIONSPECIFICATIONS
PECIFICATIONS
37306
3730637306
37306
N100
TO
N120
25
MM
P
ORT
A
DAPTOR
Dimensions(mm):
DIA132.2×35.8
Type:
N100 to N120 port adaptor
Remark: Nauticam supports only e-manuals. Please download
corresponding product manuals on Nauticam.com website, or contact
us for e-manuals.