www.naxa.com Page 3
Connecting
1) Set your iPod audio dock to iPod mode.
(Refer to the manual of your iPod audio
dock for instructions.)
2) Connect the NAB-4000 to the iPod audio
dock. The dock connector is found on the
bottom of the unit.
3) The NAB-4000 will turn on automatically
and the status indicator will ash slowly.
A beep will sound when the unit has been
recognized.
Once connected for the rst time, the unit will
turn on automatically. If it does not, press and
hold the Pair button for 3+ seconds to turn it on.
To turn off the unit, press and hold the
Power/Pair button.
Pairing
Before using a wireless player with Bluetooth(r),
you will need to establish a connection between
it and your Naxa device. This process is called
“pairing” and you will only have to do it once.
Once two devices are paired, they will automat-
ically connect when they detect each other.
Wireless players with Bluetooth may include
laptops, tablets, smartphones, and more. Make
sure that your player has its Bluetooth radio
enabled and that it is set to be discoverable.
1) When the NAB-4000 turns on and has
been recognized, the Status indicator will
ash slowly (searching) and then ash
quickly (pairing).
2) While the unit is ashing quickly, use the
