NCR 7409-K400 User manual

7409‐K400
CD/DVDROMDrive
KitInstructions
Issue A

ii
Revision Record
Issue Date Remarks
A Jan 2009 First issue

1
Introduction
This kit provides an integrated CD/DVD ROM Drive for the 7409.
26958
DVD SATA and Power Cable
497-0455758 SATA DVD ROM Drive
006-8614321
Screw, M2 x 2.4 - 2.7mm, Phillips, Pan Hd
006-8611076
CD/DVD Bracket
497-0463593

2
Installation Procedures
Warning: Disconnect the AC power cord before disassembling the Terminal.
1. Remove the Display Head from its mount.
Removing the 7409 from the Table Top Mount
a. Release the Mounting Plate Latches and tilt the display back. Relock the latches.
26901
Mounting Plate Latches
b. Loosen the captive screw that secures the Cable Cover and remove the cover.
26690
Cable Cover Captive Screw

3
c. Disconnect the cables from the I/O Panel.
26445a
Terminal Power Cable
Printer USB Cable
Keyboard USB Cable
d. Release the Mounting Plate Latches and remove the 7409 from the mount.
26659
Mounting Plate Latches
Baseplate

4
Removing the 7409 from the Fixed Angle Mount
a. Remove the screws (2) in the sides of the Fixed Angle Mount.
26681
Screw
(One on each side)

5
b. Rest the bottom of the display on the Display Support.
26680
Display Support
Cable Cover Captive Screw
Note: Place the Display Support behind the extension on then Display Hinge
Bracket.
24753
Display Support
Bracket Extension
c. Loosen the captive screw that secures the Cable Cover and remove the cover.

6
d. Disconnect the cables from the I/O Panel.
Note: The Power Cable connector locks into position when connected to the terminal
and cannot be removed by simply pulling on the cable. You must grasp the connector
and slide the outside housing out from the terminal to unlock it from the terminal
connector.
26445
Terminal Power Cable
Printer USB Cable
Keyboard USB Cable
e. Slide the Locking Brackets (2) to the unlocked position.
24747

7
f. Remove the display from the Fixed Angle Mount.
24629
g. Disconnect the Power Cord from the I/O Panel on the terminal.
2. Lay the terminal face down on a flat surface.
3. Loosen the captive screws (2) that lock the Rear Cover.
26903
Captive Screws
Rear Cover

8
4. Pivot the Rear Cover to the open position.
5. Connect the DVD SATA and Power Cables to the Motherboard.
6. Install the drive.
a. Fold the cables under the CD/DVD ROM Drive as shown below.
b. Insert the two extensions on the CD/DVD RPM Bracket in the two slots in the chassis.
c. Secure the CD/DVD ROM Bracket with the thumbscrew.
26956
SATA
Power
Slots for CD/DVD ROM Bracket Extensions
Thumbscrew
Secured Here

9
26957a
Installed CD/DVD ROM Drive
7. Replace the Rear Cover and mount the Display Head to its mount using the reverse
procedures.
8. Close the Rear Cover and replace the Display Head to its mount using the reverse
procedures.

10
Accessing the DVD
The DVD is accessed by removing the Access Cover on the side of the display (1 screw).
26959
Access Cover
CD/DVD ROM Drive