Nero 74409099 User manual

User Manual
Soluon
switched on.
• The circuit breaker has tripped or the
fuse has blown.
• The temperature control is set at "O"
• T he temperature control dial may be
set too high.
• Check if the coolers drain pan is full.
• Appliance is not on a level, firm
surface or may be touching other items.
• Check the temperature control
dial is set at "3".
• A higher external ambient tempera-
ture may require a higher seng.
• The door is opened too oen.
• The door is not closed completely.
• The door gasket does not seal
properly.
• The Cooler does not have the
correct clearances at the sides/back.
• This is a result of the dissipaon of
the heat from inside the cabinet.
Problem
Your refrigerator does not
operate
Your refrigerator is
too cold
Your refrigerator is not cold
enough
The defrosng water
overflows inside the cooler
and onto the floor
The side panel heats up
Condensaon forms on the
outside of the cooler
The cooler seems to make
too much noise
• Condensaon will form on the
outside of the cooler if it operates in
moist areas, simply wipe it dry.
TROUBLESHOOTING
Beforereturning your Nero Refrigerator to the store, check the following
points; you may be able to solve any problem yourself.
• Checkpower cable is plugged in and
working. The automac cycles ensure the defrosng is done in the most efficient manner, and
when required. It is not recommended to leave the fridge in the manually set defrost mode for
prolonged periods of me.
• Note it is normal to hear refrigerant
flowing as the compressor stops and starts.
IMPORTANT
The fridge will go through a normal periodical defrosng cycle, and a manual defrosng
operaon is only require in most extreme cases. It is beer to avoid if not necessary.
While in the ‘defrost’ mode, the fridge cooling power is reduced , as the compressor is not
8
NOTE: Do not recommend to operate the fridge on sengs that run below 4°c/MAX,
as such sengs will cause content atthe rear of the fridge closetoevaporatorto
freeze, and will r esult in unnecessary strain on the cooling systems, and undue high
energy consumpon.
Note: in normal operaon the controller turns the compressor off at the set
temperature, and back on aer the temperature had risen by around 5°c.
As such, the reading in the electronic controller is almost always a few degrees above -
poinset and that, t is perfectly OK.
90L Glass Door Fridge
Stainless Steel
Product No.74409099
Backed by the Nero 2 Year Warranty
Imported By:
R Weatherdon & Co Pty Ltd
www.weatherdon.com.au
Made In China

Operaon is very simple, but please take a few minutes to read this booklet. It contains safety
informaon and ps to ensure you receive the best operation performance from your Fridge
.
Important Safety Instrucons
arng the installaon, consideraon should
be given to how the installaon is to be carried out,
Adequate space and clearances.
Prevenng exposure to the elements.
Prevenng any exposure to direct sun light.
Availability of earthed power.
The mechanical strength of supporng
structures.
The installaon work must be undertaken by a
qualified and competent person in conformity to the
rules concerning connecon of electric power and
wiring rules.
The manufacturer does not accept any liability for any
damage or injury caused by improper installaon.
Before connecng to the mains supply ensure that
the mains voltage corresponds with the voltage on
the Refrigerator’s rang label.
Make sure the electric plant of your house is correctly
When installed, the Fridge must be posioned to
ensure no moisture ingress into the appliance or the
appliance compartment.
Before carrying out any kind of maintenance or
cleaning, disconnect the Fridge from the mains
supply.
The appliance must not be operated or le out in
the weather. Do not expose the Refrigerator to
rain or wet condions.
To ensure safe operaon, please read this instrucon manual thoroughly before use.
Welcome to your new
Fridge
Thank you for purchasing this fridge. It has been designed and manufactured for of trouble -free
Before st
ensuring
earthed.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilies, or lack of experience and
knowledge, unless they have been given supervision or
instrucon concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
There shall be adequate venlaon of the area when
the Refrigerator is used, and vents provided must be
kept clear, clean and open.
There is a fire risk if cleaning is not carried out in
accordance with the instrucons, or if damage occurs to
cooling system.
Always ensure the R efrigerator is kept at the correct
sengs for the required operaon of the appliance.
Do not use cooking utensils to handle things inside, or
clean the interior of the fridge, as damage to liners may
result.
During use rear of appliance becomes hot. Care should
be taken to avoid touching elements at rear of the
Fridge.
Children should never be allowed to sit or stand on any
part of the appliance.
Use this appliance only for its intended use.
It is designed to be used in sheltered areas only and
must not be exposed to the elements.
NOTE:
THE REFRIGERATOR MUST NEVER
OPERATE IN DIRECT SUNLIGHT!
The refrigerator will not operate to specifications if sunlight penetrates
the glass doors. Prolonged exposure to direct sunlight inside the fridge
will result in increased temperature, excessive energy consumption, and
even premature component failure, and will not be covered by warranty.
many years
service.
2
Replacing Lamps
Your Fridge is using a long- life, energy-saving LED light tube. Should you need to
replace this light, please contact your nearest stockist or service agent for a
suitable replacement part.
To change the light tube:
1. Unplug the power plug and ensure the light switch is off.
2.
3.
4.
For models with light cover, remove the screws on both ends of the light
cover, take off the lamp cover, pull out the wires slightly.
Gently pull out the connector at the end of the light tube.
Insert the connector into the new lamp, place the lamp cover and fasten it.
Images in this manual are for illustrative purposes only.
Due to constant improvements, we advise that changes to
the design, material, specifications and product
configuration may occur at any time without notice.
7

Do not use damaged appliance. If you are in any doubt, consult a suitably qualified technician.
Connecon and installaon of your Fridge are to be carried out in strict compliance with the
instrucons in this manual.
For safety, the appliance must be properly earthed in accordance with specificaons
Please also Note:
Before switching your Fridge on for the first me, read the inf
ormaon in this user manual carefully.
This manual contains important informaon relang to the assembly, operaon and maintenance of the
appliance.
Please keep this booklet in a safe place for future reference. If you ever sell your Fridge, hand this
user manual to the new owner.
The manufacture does not accept responsibility for any damages that may arise due to non-observa on of
these instrucons. The user is liable for any material damage or bodily injury (product liability) caused by
using the refrigerator carelessly or failing to follow instrucons.
Do not damage any parts of the appliance which carry refrigerant by piercing, perforang, crushing,
twisng or scraping. If the refrigerant comes into contact with the eyes, it may cause serious eye injury.
Always remember to unplug the appliance before cleaning. Never unplug your appliance by pulling on the
power cable. Always grip plug firmly and pull straight out from the socket. Always check that the plug and
cable are undamaged.
All repairs must be carried out by a qualified technician. Inadequate repairs may be dangerous. Never try
to repair the refrigerator yourself.
Should the cover of the interior light or fan fall off or break, switch the refrigerator off immediately and
replace the cover.
Ensure your chosen locaon has a flat and stable surface. The unit may be leveled by turning either or
both of the adjustable feet in the front corners. Check the unit is level using a spirit level.
Do not obstruct or cover the venlaon aperture.
Make sure there is a suitable power Outlet (240 volts, 10 amps outlet) with proper grounding to power
the refrigerator.
Disposal of Old Appliances
Be sure to make any locks unusable, remove any door(s) and discard separately.
Warning – chemical hazard: do not allow children to play with the old appliance.
Contact your local authority for disposal procedures.
Before disposing of an old appliance, please make sure it is switched off and safe. Unplug the
appliance and break any locks in order to avoid children becoming trapped.
Please note : refrigeraon system contains gas and refrigerants which require speciali sed waste
disposal. Some vulnerable materials in a refrigerator can be recycled. Contact your local waste
disposal depot for proper disposal of an old appliance and contact your local authority or dealer if
you have any quesons.
Please ensure the cooling systems and tubes of your refrigerator are not damaged prior to disposal.
You can contribute to environmental awareness by insisng on an appropriate non-pollung method
of disposal.
Disposal of Packaging
Do not allow children to play with the packaging, and dispose of plasc bags safely.
The cardboard may be broken or cut into smaller pieces and recycled . Any wrapping cover is made of
polyethylene. The polyethylene pads and padding contain no fluorochloric hydrocarbons, and as such
are most suitable for adequate recycling .
36

Cleaning
1Unplug your Fridge from power source and remove any items from inside. It is best to
place these temporarily in another refrigerator.
2. Wash the inner compartment with warm water and neutral mild detergent. DO NOT allow the
control panel, cables or plug to get wet.
NEVER use corrosive detergents, wire blasters, or abrasive scourers to clean your
Fridge.
NEVER use metal or sharp implements to scrape any part of the fridge.
3. Dry all surface thoroughly.
4. To ensure trouble -free operaon the condenser should be cleaned every three months where
appropriate using a vacuum hose. The condenser is located behind lower grill of the cabinet. In
exceponally dusty.
It is recommended that areas around the condenser are cleaned more oen.
5. Use mild soapy water to clean the gasket and seals around the door.
6. The external surfaces of the fridge can be cleaned with warm water and mild detergent.
IMPORTANT: allow the refrigerator to stand still and
upright for 8 hours before plugging it into the power!
Before Using For the First Time
Do not posion this appliance with its rear panel directly against a wall. For good circulaon and
operang efficiency, the venlaon grilles must never be blocked.
Remove all packaging and place the Fridge on a stable, secure flat surface. Posion the
Fridge away fr om heat sources, where the unit is well -venlated and protected from
moisture, or extremes of heat or cold. The refrigerator may not funcon properly if the ambient
temperature rises above +40 for prolonged periods of me.
Ensur e the vents behind the fridge are clear, and clean, and not obstructed from the other side,
such that air circulaon is enabled.
Do Not Use An Extension Lead. If the mains cable will not reach the nearest socket, either
rearrange your installaon layout or ask a qualified electrician to fit a new socket.
If power is cut off, wait for at least 5 minutes before plugging the unit in again to avoid damaging
the compressor.
Do not place combusble, explosive or volale arcles, corrosive acid or alkali, or liquid in glass
containers into the Fridge.. Always exercise cauon if adjusng the temperature.
4
MechanicalController
The mechanical thermostat temperature control and the L IGH T on/off switch is located
at below places:
Therm ostat
control
OFF
ON
6
7
Therm ostat cont rol Light Switch
Light Switch
There are several types of controller/thermostat for different models.
Please check which type of controller on your unit.
Thermostat sengs
Thermostat “0” posion indicates the Refrigerator is turn off although
power is sll being supplied. By turning the thermostat dial clockwise,
the Refrigerator will turn on automacally. The sengs 1(MIN) - 7 (MAX)
regulate the interior temperature of the Refrigerator.
Seng 0 = Off (not operang)
Seng 1 (or MIN) = lowest seng (warmest internal temperature)
Seng 7 (or MAX) = highest seng (coldest internal temperature)
Adjust the internal temperature as required according to the amount of
product and the ambient temperature.
The internal temperature varies in different parts of the Refrigerator.
The back of the Refrigerator is coldest.
Back of unit
Thermostat sengs
Thermostat “OFF” posion indicates the Refrigerator is turned off although
power is sll being supplied. By turning the thermostat dial clockwise,
the Refrigerator will turn on automacally. The sengs MIN - MAX
regulate the interior temperature of the Refrigerator.
Seng Off = not operang
Seng MIN = lowest seng (warmest internal
temperature)
Seng MAX = highest seng (coldest internal
temperature)
Adjust the internal temperature as required according to the amount of
product and the ambient temperature.
The internal temperature varies in different parts of the Refrigerator. The
2.
1.
Thermostat sengs
To operate
Tips for refrigeraon
MAX
OFF
MIN
1
2
3
4
5
5
back of the Refrigerator is coldest.
LOOKI N G A FTE R THE PROD U CT-DEF R O STI N G :
Ice may build up on the evaporator if the unit is put to work constantly for a period of me. When ice begins to build up to
approx 10 mm or1/5 inch thick, defrost is required.
Empty the cabinet of the products that must stay at cold condion. Switch the thermostat to “OFF”posion.
The ice will start to melt. When the ice has melted and drained away, dry off any residual moisture with a so cloth. Switch on the
power again via thermostat.
Please note it will take around 12 hours for the cabinet to get back down to temperature with the products.
Type Ⅰ:
Type Ⅱ:
Type Ⅲ:
12
3
4
5
The temperature in the appliance is controlled by the temperature
control knob located on the rear of the fridge on the outside of the
product. Rotate the control knob le or right to regulate the temp-
erature inside the fridge, you may need a flat headed screw driver
or a coin to do this.
The seng 1(MIN)-5(MAX) regulate the interior temperature.
Seng 1 (or MIN) = lowest seng (warmest internal temperature)
Seng 5 (or MAX) = highest seng (coldest internal temperature)
Toturntheunitoff,disconnecttheplugfromthemainssupply.