NetTalk Duo wifi User manual

NETTALK DUO WIFI SETUP GUIDE – Ad-Hoc Mode

2
Step 1. Power up the DUO Wi-Fi
Step 2. Press the reset button 5 times
a. Use the supplied USB cable and power adapter.
a. To press this button, which is located next to the USB/power socket, you
need a paper clip, or similar sharp object.
USB RESET
USB RESET

3
a. On your computer, look at the list of available wireless networks. One should
start with the word netTALK- followed by four letters and numbers.
1. Example: netTALK-04ac
b. Connect to the new wireless network described above.
c. When asked for the password, type this exactly.
1. 71794a2139 (Make sure the letter a is a lower case)
Step 4: Connect to wireless network
Step 3. Look for the blinking lights
a. After a few seconds, the light on the DUO WiFi should begin blinking with three
quick orange blinks, then two longe red blinks, then repeating that pattern.
USB RESET USB RESET USB RESET USB RESET USB RESET

4
Step 5. Open your web browser
Step 6. Enter your wireless router security settings
Step 7. Now view your DUO Wi-Fi’s web page even if you don’t have
an Ethernet cable connected to the device.
a. Now you can enter your wireless router security settings to work with your
DUO WiFi.
a. Open your web browser (Internet Explorer, Firefox, Chrome, etc) on your
computer to access your DUO Wi-Fi’s web page.
b. Enter the following numbers and dots in your Browser Address bar
1. 192.168.0.1
2. Press Enter
3. The DUO Wi-Fi’s web page should be displayed in your web browser.