Nima SAATI MINI User manual

MUST READ BEFORE
FIRST TIME USE:
CONTROLS:
The Bluetooth speaker is at a volume level 25%
once paired. You MUST hold down the Volume
up button (4) while playing your song to expe-
rience maximum sound performance.
www.nimausa.com
1. POWER ON/OFF
2. Volume down button / Previous Song
3. Play / Pause BT connection
4. Volume up button / Next song
5. Status LED
6. Built-In Microphone
1
3
2
5
4
BLUETOOTH WIRELESS
SPEAKER HELMET
AIRING, BUILT-IN MICROPHONE
6

• CHARGE THE SPEAKER SYSTEM
SAATI utilizes a micro USB charging port. Connect the
micro USB connector end of the cable to the unit and
the standard USB connector end to a personal com-
puter. Optionally, the standard USB cable end can be
connected to a mobile phone charger. Note that the
mobile phone charger is not supplied with the unit!
The LED indicator on the rear of the unit will stay
red until the unit is fully charged. Once charging is
complete, the LED will automatically turn off.
• TURN THE UNIT ON/OFF
Press and hold the power button for 3 to 4 seconds
until you hear audible sounds from the unit that it
is on.
To turn the unit off, simply press and hold the power but-
ton until you hear an audible that the unit is turning off.
• PAIRING
Turn on the unit. If the unit has not been paired before,
the LED indictor in the rear of the unit will blink blue.
This indicates that the unit is ready for pairing.
While the blue LED is blinking on the unit, navigate
to the Settings menu on your mobile device. Select
Bluetooth® and check that Bluetooth is enabled.
Otherwise, enable Bluetooth on your mobile device.
Then, in the Bluetooth settings screen, look under
New Devices or Other Devices and select the device
that starts with SAATI and select.
www.nimausa.com
BLUETOOTH WIRELESS
SPEAKER HELMET
AIRING, BUILT-IN MICROPHONE

• FCC STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential installat-
ion. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communication.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equip-
ment and receiver.
-- Connect the equipment into an outlet on a
circuit different from that to which the rece-
iver is connected.
-- Consult the dealer or an experienced radio
/TV technician for help.
Changes or modifications not expressly appro
ved by the party responsible for compliance c
ould void the user's authority to operate the
equipment.