nLight nECYD EXT150 User manual

1 of 2Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: [phone] www.acuitybrands.com © 2019 Acuity Brands Lighting, Inc. All rights reserved. Rev. 12/30/2019
nECYD EXT150
Installation Guide
DC IN

2 of 2Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: [phone] www.acuitybrands.com © 2019 Acuity Brands Lighting, Inc. All rights reserved. Rev. 12/30/2019
Installation
The nECYD EXT150 is a rugged, industrial-
grade USB 2.0 repeater/extender that can be
used to extend the distance between an nLight
ECLYPSE (nECY) and an nLight Air Adapter
(nECYD NLTAIR G2) by up to 150ft (45m). The
nECYD EXT150 works in pair (one transmitter and
one receiver) to extend the distance over CAT6
cables.
DCIN
SUBNET DEVICE
POWER POWER STATUS
24VAC/DC
24V COM
HOST
S
nLight
1
2x
nLight
2
nLight/
nGWY2 GFX
10/100
ETHERNET SWITCH
RS-485
NET+ NET- S
PRI SEC
1 2
3
3
nLight ECLYPSE
™
nLight ECLYPSE
™
nLight ECLYPSE
™
nLight
®
Interface
Controller
PS24
USB
CAT6 CABLE
(LENGTH UP
TO 150’)
NECYD EXT150
(SECONDARY SIDE)
TO 120V
POWER
120V
ADAPTER
NECYD EXT150
(PRIMARY SIDE)
NECY MVOLT ENC (BAC) (SVS) (SVEA) (GFXK)
NLIGHT AIR
ADAPTER
USB
(NOT PLENUM
RATED)
Connect primary side of
nECYD EXT150 to either
USB port on the nLight
ECLYPSE controller module.
Connect the secondary side
of the nECYD EXT150 to
the wall adapter.
Plug the wall adapter into a
120VAC source.
Connect the primary and
secondary components
using CAT6 cable.
Connect the secondary side
to the nECYD NLTAIR G2.
1
S
T
E
P
2
S
T
E
P
3
S
T
E
P
4
S
T
E
P
5
S
T
E
P
SUBNET DEVICE
POWER POWER STATUS
24VAC/DC
24V COM
HOST
S
nLight
1
2x
nLight
2
nLight/
nGWY2 GFX
10/100
ETHERNET SWITCH
RS-485
NET+ NET- S
PRI SEC
1 2
3
3
nLight ECLYPSE
™
nLight ECLYPSE
™
nLight ECLYPSE
™
nLight
®
Interface
Controller
PS24
DCIN
NOTE
CAT5e/CAT5 cable is not approved for use with this
device. Cable length of CAT6 cable shall not exceed
150 ft. (45m) in length.