Nordost QRT QNET STAND User manual

QNET STAND
Easily support your QNET NETWORK
SWITCH with Sort Kones for optimum
performance with resonance control.

LEGS (x3)
TOP
BOTTOM
CENTER PIECE RING
Sort Kone
Depression
Groove
for Ring
Pins
SIDE
COMPONENTS:

Place center piece flat
on a table with the pin
side up.
Slide 3 legs onto pins with the slot for
the rubber gasket and the Sort Kone
depressions facing down.
ASSEMBLY:

With the grooves facing up, take
the rubber ring and stretch it with
both hands so that it can snap into
the groove on one of the legs.
Repeat with the second leg, and
then the third.
Carefully flip the stand over so that
the legs do not slide o.

Spaces
XXXXXXX
Lay the QNET upside down (with the vents
facing down) on a flat surface. Lay the
Stand on it so the legs fall symetrically, or
approximately where you would like them.
Hook two of the legs onto the edge of the unit and stretch the third
so that it can snap on and secure the Stand to the QNET.
ATTACHING:

Spaces
Adjust so that the spaces
between the legs and the
center piece are about even.
Flip the unit over and set on
three Sort Kones so the tips
fit into the depressions.
FINISHING:

See www.nordost.com/downloads.php
for more language options