Normann Puff Twist User manual
Pu Table Lamp Twist
Assembly Instructions
Assembly Instructions Pu Table Lamp Twist
1
!
ENGLISH
IMPORTANT
Always shut o power to the circuit before start-
ing installation work. In some countries electrical
installation work may only be carried out by an
authorised electrical contractor. Contact your
local electricity authority for advice.
DEUTSCH
WICHTIG!
Vor der Installation den Strom abschalten.
In einigen Ländern dürfen Elektroinstallationen
nur von autorisierten Elektrofa-chleuten ausge-
führt werden. Im Zweifelsfall die örtlichen Behör-
den ansprechen.
FRANÇAIS
ATTENTION !
Toujours couper l'alimentation au panneau prin-
cipal avant de procéder à l'installation. Dans
certains pays, l'installation doit être en savoir plus,
contacter les autorités locales compétentes en la
matiére.
NEDERLANDS
BELANGRIJK!
Schakel de stroom altijd uit voordat met de instal-
latie wordt begonnen. In sommige landen mogen
elektrische installaties alleen worden uitgevoerd
door een bevoegd elektricien. Neem daarom con-
tact op met de plaatselijke overheid voor advies.
DANSK
VIGTIGT!
Sluk altid for strømmen, før installationen påbe-
gyndes. I nogle lande må elektriske installationer
kun udføres af en uddannet elektriker. Få oplys-
ninger hos de relevante myndigheder.
ÍSLENSKA
MIKILVÆGT
Sláið rafmagnið úr áður en uppsetning hefst.
Í sumum löndum þarf uppsetning að vera fram-
kvæmd af löggiltum rafvirkja. Leitið ráða hjá raf-
virkja varðandi uppsetninguna.
NORSK
VIKTIG!
Elektriske installasjoner skal utføres av elektriker.
Steng av strømtilførselen til strømkretsen med
riktig sikring før installasjonsarbeidet påbegynnes.
SUOMI
TÄRKEÄÄ!
Katkaise aina virta pääkatkaisimesta ennen asen-
nuksen aloittamista. Joissakin maissa asennuksen
saa tehdä ainoastaan ammattitaitoinen säh-
köasentaja. Ota selvää paikallisista määräykistä.
Assembly Instructions Pu Table Lamp Twist
2
3
Assembly Instructions Pu Table Lamp Twist
4
5
WARNING: Please be careful during assembly, as the rice paper material is fragile
Assembly Instructions Pu Table Lamp Twist
6General Instructions
Please note the information contained in these instructions and save this manual, also when the lamp is
already mounted.
Safety precautions:
• Electrical connections may only be carried out by qualied sta.
• The manufactures do not accept responsibility for injuries or defects caused by improper use of this
lamp.
• Attention! Before starting the installation, disconnect the power by turning o the circuit breaker, or
by removing the fuse at the fuse box.
• Mind to use this lamp for its predetermined function. For example don’t mount indoor lamps in
outdoor areas.
• Please check all components are complete before installing.
• Don’t cover the lamp.
• Don’t connect the lamp to power and don’t switch it on when it’s in packing.
• Bulbs and transformers get very hot during operating. At improper use there is the risk of re and by
changing the bulb you can hurt yourself. Always let cool down!
• If the external exible cable or cord is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualied person in order to avoid a hazard.
• Please ensure that the specied bulb type and power of bulb is used. The maximal wattage
shouldn’t be exceeded (nd the bulb symbol and the ”max ... W” on rating label or on the lamp).
• Do not mount the lamp on wet or conducting background.
• Make sure that the cables or cords don’t get damaged during installation.
• The given main voltage (220-240V ~ 50-60Hz) shall not be exceeded.
• Plug and connection elements must be free of tensile strength and torsion force.
• Don’t touch bulbs with bare hands.
• If the product is damaged, please contact Normann Copenhagen for replacements.
Maintenance instructions:
• Before cleaning, disconnect the power by turning o the circuit breaker, or by removing the fuse at
the fuse box.
• Mind to clean the surfaces of the lamp only.
• Wetness shouldn’t get in terminal box or to any conducting part.
• Let the lamp cool down for 10 minutes before cleaning.
• Clean the lamp with a soft dry, cloth only.
Advice for environmental care:
Please don’t dispose of this article in normal domestic waste after the end of its lifecycle.
Instead, we advise that you dispose of it according to local environmental laws for waste disposal.
The materials are recyclable according to their specications. With the correct recycling of these materials,
you can make a signicant contribution to environmental protection.
The battery must be removed from the lamp and disposed of according to local environmental laws before
disposing of the lamp.
CE marking:
By axing the CE marking to a product, a manufacturer declares that the product meets all the legal
requirements for CE marking and can be sold throughout the European EconomicArea (EEA).
Other Normann Home Lighting manuals
