North American Tool 6212 User manual

8806212 12/12
22 TON LOG SPLITTER
CALIFORNIA PROPOSITION 65
WARNING: You can create dust
when you cut, sand, drill or grind
materials such as wood, paint,
metal, concrete, cement, or other
masonry. This dust often
contains chemicals known to
cause cancer, birth defects, or
other reproductive harm. Wear
protective gear.
WARNING: This product or its
power cord may contain
chemicals, including lead,
known to the State of California
to cause cancer and birth
defects or other reproductive
harm. Wash hands after
handling.
Important!
When using equipment, a few
safety precautions must be
observed to avoid injuries and
damage. Please read the complete
operating manual with due care.
Keep this manual in a safe place,
so that the information is available
at all times. If you give the
equipment to any other person,
give them these operating
instructions as well. We accept no
liability for damage or
accidents which arise due to non-
observance of these instructions
and the safety information herein.
SPECIFICATIONS
Max Pressure: 3500 PSI
Max Flow: 10.8 gp
Hydraulic Fluid Type: 2.5
gallons of 10wt AW32, ASLE H-
150 or ISO32.
Coupler Size: 2 inch ball
Max Log Length: 24 inches
Max Log Weight: 100 pounds
Max Log Diameter: 12 inches
CAUTION:
FOR YOUR OWN SAFETY,
READ INSTRUCTION MANUAL
COMPLETELY AND
CAREFULLY BEFORE
OPERATING THIS LOG
SPLITTER.
Any failures made in following
the safety regulations and
instructions may result in an
electric shock, fire, and/or
serious injury.
Model: 6212
SAFETY INSTRUCTIONS
WARNINING: Improper use of a
log splitter can cause injury and
death.
Keep the work area clean and well
lit.
Do not use this tool in damp or
wet conditions. Do not expose it to
rain.
Store idle equipment. When the
tool is not in use, store it in a dry
location.
Do not attempt to use the tool for
a purpose it was not intended to
be used for. Do not force the tool
to do work it was not meant to do.
Do not overreach when using the
tool. Keep proper footing and
balance at all times.
Stay alert while operating the tool.
Do not operate the tool under the
influence of drugs or alcohol.
[e-mail]

2
Check for damaged or
misaligned parts before using the
splitter. Do not use the splitter if
it is damaged and have it
serviced before use.
Keep both hands away from
edge plate during use. Wedge
can cut through sin and break
bones.
Wear safety glasses to avoid eye
injury from pieces of log that may
fly out while splitting.
High pressure fluid can inject
under skin resulting in serious
injury. Make sure all fittings are
tight before applying pressure.
Relieve system pressure before
servicing. Do not check for leaks
with hand. Use a piece of
cardboard to check for leaks. If
skin injection occurs, seek
immediate treatment.
Serious injury or death can occur
if splitter is improperly towed.
Do not ride or transport cargo on
the splitter. Drive with the splitter
securely attached. Turn off the
vehicle before leaving the splitter
unattended. Choose a level
surface to operate the splitter
and block the wheels to prevent
rolling.
Position muffler at least 7 feet
away from combustible objects.
Stop the engine before adding
fuel and keep heat, sparks and
flames away.
Do not add fuel while the engine
is still running or hot.
Use an approved container to
add fuel to the splitter. Do not
pump fuel directly into the splitter
at a gas station.
Do not change or add to the
exhaust system, fuel tanks or
fuel lines.
Check for fuel leaks before use.
OPERATING
INSTRUCTIONS
1) Load a log onto the beam and
against the endplate.
2) Make sure hands are clear of
the splitter.
3) Push control valve handle
forward by one hand to split log.
4) Push control valve handle
backward by one hand to return
wedge to original position.
5) Clear split wood from work
area.
MAINTENANCE
Before performing maintenance,
ensure the engine is turned off
and move the control handle
forwards and backwards to
relieve hydraulic pressure.
After performing maintenance,
ensure all guards, shields and
safety features are put back in
place. Failure to do so can result
in injury.
Refer to the engine owner’s
manual for engine maintenance.
Inspect for exposed wire mesh
and leaks on the hoses before
each use. Replace all worn and
damaged hoses before starting
engine.
Inspect for cracks and leaks in
the hydraulic fittings before
each use. Replace all damaged
fittings before starting engine.
Check for loose nuts and bolts
before each use. Tighten loose
nuts and bolts before use.
Apply grease to beam surface
before each use.
Clear debris from moving parts
before each use.
[e-mail]

3
ASSEMBLY
[e-mail]

4
ASSEMBLY (continued)
[e-mail]

North American Tool (NAT) Industries makes every effort to ensure that this product meets high
quality and durability standards. NAT warrants to the original retail consumer a 1-year limited warranty
from the date the product was purchased at retail and each product is free from defects in materials.
Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, or
accidents, repairs or alterations, or a lack of maintenance. NAT shall in no event be liable for death,
injuries to persons or property, or for incidental, special, or consequential damages arising from the
use of our products. To receive service under warranty, the original manufacturer part must be
returned for examination by an authorized service center. Shipping and handling charges may apply. If
a defect is found, NAT will either repair or replace the product at its discretion.
5
DO NOT RETURN TO STORE
For Customer Service:
Email [e-mail] or Call 1-800-348-5004
[e-mail]

8906212 12/12
22 TON LOG SPLITTER
Model: 6212
6
[e-mail]

7
[e-mail]

8
[e-mail]