Nurseryworks LOOM CRIB CONVERSION KIT User manual

LOOM CRIB CONVERSION KIT
Instrucon Manual
revised 22SEP2011
Congratulations!
You are now the owner of a Nurseryworks
product...a line of modern baby furniture that
redefines the nursery. Nurseryworks’ products
are designed with both style and functionality
in mind, and we hope it becomes a source of
pleasure for you and your family. Quality material,
workmanship and pride have gone into these
products. Proper assembly is important to
ensure a safe and comfortable end result for
your baby. Please read all instructions before
assembly, and keep instructions for future use.

ENTRAPMENT/
STRANGULATION HAZARD
1
WARNING
!
•Infants have died in toddler beds from entrapment
and strangulation.
• NEVER use bed with children under 15 months.
• Guardrails must be used to avoid the formation
of a gap between the mattress and the bed that
could cause an entrapment.
• Do not suspend strings over a toddler bed for
any reason.
• For toddler bed: The minimum age shall not be
less than 15 months and the maximum weight
shall not be greater than 50lb (22.7 kg).

Loom Crib Conversion Kit
Tools and Parts List
x1
Be sure you follow the instructions in the order that they appear.
To avoid possible scratching, assemble furniture on a soft surface.
For instance on a carpet or blanket.
Be aware that you can use both ends of the Allen wrench.
For instance, use it lengthwise to get into tighter corners.
Be careful not to over tighten screws.
Hx1
2

Installation of Conversion Kit
Unscrew Screw A with Wrench Hand take out the
mattress board and one of Crib Slate Panel .
3

Attach Conversion Kit to one End Panel by
aligning the Female Rail Clip G (pre-installed in the
top rail of Slat Panel ) above the Male Rail Clip F.
Push down firmly to set in place.
Then screw one Plate E into the holes along the
bottom of Slat Panel with three Screw B (existing
screw on the mattress support board) and tighten
with Allen Wrench H.
Installation of Conversion Kit
4