SportFloor® Stamina
Maintenance Manual
North West Rubber Ltd. SportFloor® Stamina Maintenance Manual
33850 Industrial Avenue, Abbotsford BC V2S 7T9
Tel: 604.859.2002 Fax: 604.859.2009 Page 2 of 3 Rev: 8/18/2021
•Recommended cleaner is TASKI™ Profi®or a similar PH neutral bio-degradable cleaner.
•For safety, post “Wet Floor” signs, use caution tape or barricade the area from entry.
•Refer to Safety Data Sheets (SDS) for proper personal protective equipment before working with chemicals.
•Mix the appropriate ratio of the cleaner as recommended by the manufacturer.
Note: Test diluted solution on small area of floor surface to measure its efficiency. If it is not producing desired results,
slightly adjust your mixing ratio accordingly.
•Using a mop, apply approved floor cleaner diluted with clean water.
•Follow cleaning product manufacturer’s instructions and allow solution to stand for 5-10 minutes after application, but do
not allow surface to dry out.
•While still wet, scrub floor using a rotary buffing machine equipped with a medium Scotch Brite® pad.
•Scrub surface in multiple directions with the rotary buffing machine and remove wet residue using a wet-dry vacuum.
•Damp mop rinse the surface thoroughly using clean fresh water.
•Repeat cleaning as required to remove any remaining mold release or sediment.
•Insufficient rinsing of the flooring surface after it has been washed can lead to the accumulation of soap residue. Repeat
rinsing as required to remove all residues.
•Prohibit foot traffic on flooring until area is dry.
B.
Regular Cleaning:
(Minimum Once Weekly)
•For safety, post wet floor signs, caution tape or barricade area from entry.
•Refer to Safety Data Sheets (SDS) for proper personal protective equipment before working with chemicals.
•Begin by thoroughly vacuuming or sweeping the
SportFloor® Stamina
surface.
•Using a mop, apply approved floor cleaner diluted with clean water. Depending on how soiled the area is, you may choose
to increase the concentration of the cleaner.
•Follow cleaning product manufacturer’s instructions and allow solution to stand for 5-10 minutes, but do not allow surface
to dry out.
•Scrub floor using a rotary buffing machine equipped with a medium Scotch Brite® pad.
•Scrub surface in multiple directions and remove wet residue using a wet-dry vacuum.
•Damp mop rinse the surface thoroughly with clean fresh water.
•Insufficient rinsing of the flooring surface after it has been washed can lead to the accumulation of soap residue. Repeat
rinsing as required to remove all residues.
•Prohibit foot traffic on flooring until area is dry.
C.
Restorative Cleaning:
(As required or approximately every 2-3 years.)
•For safety, post wet floor signs, caution tape or barricade the area from entry.
•Refer to Safety Data Sheets (SDS) for proper personal protective equipment before working with chemicals.
•Begin by thoroughly vacuuming or sweeping the
SportFloor® Stamina
surface.
•Use Diversey™ LinoSAFE® and mix to manufacturers suggested ratio as required for condition of flooring.
•Using a mop, apply mixed floor cleaner diluted with clean water.
•Allow solution to stand for 10-20 minutes but do not let surface dry out before scrubbing.
•Scrub floor using a rotary buffing machine equipped with a purple Scotch Brite®pad or nylon brush.
•Scrub surface in multiple directions and remove wet residue using a wet-dry vacuum.
•Damp mop rinse the surface thoroughly with clean fresh water.
•Repeat cleaning as required removing any remaining sediment or “applied finish” material.
•Insufficient rinsing of the flooring surface after it has been washed can lead to the accumulation of soap residue. Repeat
rinsing as required to remove all residues.
•Prohibit foot traffic on flooring until area is dry.
III. Waxes and Coatings
SportFloor® Stamina
does not require an applied finish.
•A regular maintenance regimen is all that is needed to care for your rubber flooring.
