OmniMed 350714 User manual

800 Glen Avenue • Moorestown, N.J. 08057
800.257.2326 • FAX: [phone]
www.omnimedbeam.com
Instruction Sheet
ERGO Computer Transport Stand #350714
0311.AS.OMNI
Unpack the cartons and check carefully
to determine that all of the components
have been supplied. Note that a 7/16”
wrench and a phillips head screwdriver
are required for assembly.
Use the screws provided with your monitor
to attach it to the monitor plate. The
dual lock provided in the Hardware kit
can be used to fasten the keyboard
to the keyboard tray.
Column
Assembly
Place the base
on the floor and
assemble the
column asssembly
Place the Top Assembly on top of
the Column Assembly and fasten in
place with the provided nuts.
Top
Assembly
Base
Hardware Kit
Dual Lock Set #2999452
1/4-20 Nut (4x) #0299310
Security Wrench #0299495

800 Glen Avenue • Moorestown, N.J. 08057
800.257.2326 • FAX: [phone]
www.omnimedbeam.com
Instruction Sheet
CPU Holder - ERGO Computer Transport Stand
0311.AS.OMNI
Use the provided security screw
wrench to loosen the Top Cover
ofthe CPU Holder
Remove the CPU Slide screw and insert
the CPU slides into the base as shown
with the smaller on top. Reinsert the
screw loosely. Loosen the screws
holding the side slide in place. Place
your CPU on the base and position
the slides closely around it. Remove
the CPU and tighten the slide screws.
Replace the CPU and secure it in by
retightening the Top Cover.
Your Transport Stand is now fully
assembled and ready for use.
CPU Slide Screw
Side Slide Screws