One Remote RIAA DIN-II User manual

OneRemote - www.oneremote.dk
1
OneRemote RIAA DIN-II
RIAA Pre-amplifier
For Bang & Olufsen Turntables,
With or without Datalink Control.
User Manual
30012730u1uk

OneRemote - www.oneremote.dk
2
Content
Introduction........................................................................................................................................................3
RIAA ....................................................................................................................................................................3
Bang & Olufsen Datalink Controlled Turntables ................................................................................................4
Plug & Play..........................................................................................................................................................5
Available Cables..................................................................................................................................................6

OneRemote - www.oneremote.dk
3
Introduction
The OneRemote RIAA DIN-II amplifier is designed for use with Bang & Olufsen turntables connected to
amplifiers without a built in RIAA amplifier, but it may be used with any turntable connected the same way.
When connected to a DataLink controlled Bang & Olufsen turntable any DataLink signal from a Bang &
Olufsen connected audiomaster is passed directly through allowing full remote control of the operation of
the turntable as specified by Bang & Olufsen for this set up.
The OneRemote RIAA DIN-II amplifier corrects the frequency response as described below and amplifies the
PU signal to line level.
The OneRemote RIAA DIN-II amplifier is supplied in a metal cabinet to maintain shielding of the signal, and it
is delivered with its own DC power supply.
RIAA
RIAA equalizaon is a specicaon for the recording and
playback of phonograph records, established by the
Recording Industry Associaon of America (RIAA). The
purposes of the equalizaon are to permit greater
recording mes, to improve sound quality, and to reduce
the groove damage that would otherwise arise during
playback.
RIAA equalizaon is a form of pre-emphasis on recording and de-emphasis on playback. A recording is made
with the low frequencies reduced and the high frequencies boosted, and on playback the opposite occurs.
The net result is a at frequency response, but with aenuaon of high frequency noise such as hiss and
clicks that arises from the recording medium.
Reducing the low frequencies also limits the excursions the cuer needs to make when cung a groove.
Groove width is thus reduced, allowing more grooves to t into a given surface area, perming longer
recording mes. This also reduces physical stresses on the stylus which might otherwise cause distoron or
groove damage during playback.
The OneRemote RIAA DIN-II amplier uses the exact same RIAA specicaons as used by Bang & Olufsen.

OneRemote - www.oneremote.dk
4
Bang & Olufsen Datalink Controlled Turntables
The Bang & Olufsen turntables without a built in RIAA amplifier listed in the table below are equipped with
DataLink enabling control via a 7-pin DIN connected Bang & Olufsen audiomaster.
The OneRemote RIAA DIN-II passes the control data from the B&O device to the record player.
Turntables that can be controlled by a B&O remote control, when connected to certain B&O Radios.
Without factory built-in RIAA amplifier.
With factory built-in RIAA amplifier.
BeoGram
2000, 2202, 2402, 3000, 3000, 4000,
4002, 4004, 5000, 5005, 5500, 6000, 6002, 6006,
8000, 8002, 8500, 9000 and 9500.
BeoGram
2400, 3500, 4500, 6500 and 7000.
The OneRemote RIAA amplifier can be used with any BeoGram model, without a factory built-in RIAA. Also,
any model not listed in the table.

OneRemote - www.oneremote.dk
5
Plug & Play
Connect the OneRemote RIAA DIN-II to the selected turntable and amplifier using the correct cables as
indicated below and power up with the supplied DC power supply. No programming required!
IN
Connect the turntable to the IN socket.
The OneRemote power supply:
•Connects to any outlet of 85-240V AC.
•Euro socket.
•DC 10V
OUT
Connect a Bang & Olufsen amplifier/receiver with a DIN socket to
OUT using a DataLink cable or a OneRemote PH-DLINK cable.
Cables are not included.

OneRemote - www.oneremote.dk
6
Available Cables
OneRemote supplies these cables for use between the OneRemote RIAA DIN-II amplifier and the
amplifier/receiver.
Part number
PH-DLINK 0.5 meter white 39202070
PH-DLINK 1 meter white 39202071
PH-DLINK 3 meter white 39202073